Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
Standard Specification for Copper Sheet, Strip, Plate, and Rolled Bar
Přeložit název
NORMA vydána dne 1.10.2019
Označení normy: ASTM B152/B152M-19
Poznámka: NEPLATNÁ
Datum vydání normy: 1.10.2019
Kód zboží: NS-972953
Počet stran: 6
Přibližná hmotnost: 18 g (0.04 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Keywords:
annealed, copper bars, copper plate, copper sheet, copper strip, hot-rolled, rolled, UNS No. C10100, UNS No. C10200, UNS No. C10300, UNS No. C10400, UNS No. C10500, UNS No. C10700, UNS No. C10800, UNS No. C10910, UNS No. C11000, UNS No. C11300, UNS No. C11400, UNS No. C11600, UNS No. C12000, UNS No. C12200, UNS No. C12300, UNS No. C14200, UNS No. C14420, UNS No. C14530,, ICS Number Code 77.150.30 (Copper products)
1. Scope | ||||||||||||||||||||||||||||||||||||||||||||||||
1.1 This specification2 establishes the requirements for copper sheet, strip, plate, and rolled bar produced from the following coppers.
Note 1: Each of the coppers listed has unique properties that
can make it suitable for specific applications. The purchaser
should consult with the supplier to determine which copper would be
best suited for the intended application.
Note 2: This specification is not intended to establish
requirements for material rolled to ounce-weight thicknesses. Such
material is defined in Specification B370.
Flat copper products with finished (rolled or drawn) edges (flat wire and strip) are defined in Specification B272. 1.1.1 When a specific copper is not identified in the contract or purchase order, the supplier may furnish product from any of the listed coppers. 1.2 Units—The values stated in either inch-pound units or SI units are to be regarded separately as standard. The values stated in each system are not necessarily exact equivalents; therefore, to ensure conformance with the standard, each system shall be used independently of the other and values from the two systems shall not be combined. 1.3 The following safety hazard caveat pertains only to the test method(s) described in this specification: 1.3.1 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
||||||||||||||||||||||||||||||||||||||||||||||||
2. Referenced Documents | ||||||||||||||||||||||||||||||||||||||||||||||||
|
Poskytování aktuálních informací o legislativních předpisech vyhlášených ve Sbírce zákonů od roku 1945.
Aktualizace 2x v měsíci !
Chcete vědět více informací? Podívejte se na tuto stránku.
Poslední aktualizace: 21.11.2024 (Počet položek: 2 206 478)
© Copyright 2024 NORMSERVIS s.r.o.