Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
Standard Test Method for Testing Fluid Catalytic Cracking (FCC) Catalysts by Microactivity Test
Automaticky přeložený název:
Standardní zkušební metoda pro zkoušení fluidní katalytické krakování (FCC) katalyzátorů Microactivity testu
NORMA vydána dne 1.3.2013
Označení normy: ASTM D3907/D3907M-13
Poznámka: NEPLATNÁ
Datum vydání normy: 1.3.2013
Kód zboží: NS-25300
Počet stran: 6
Přibližná hmotnost: 18 g (0.04 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Keywords:
catalysts, FCC, fluid cracking catalyst, MAT, microactivity, ICS Number Code 71.040.30 (Chemical reagents)
Significance and Use | ||||||||||||
5.1 The microactivity test provides data to assess the relative performance of FCC catalyst. Because results are affected by catalyst pretreatment, feedstock characteristics, test equipment, and operating parameters, adherence to this test method is a prerequisite for correct interpretation of results. Apparatus, test conditions, and analytical procedures actually used should closely resemble those described in this test method. 5.2 Caution should be used in interpreting results above 80 weight % conversion due to the significance of overcracking. |
||||||||||||
1. Scope | ||||||||||||
1.1 This test method covers determining the activity of equilibrium or laboratory-deactivated fluid catalytic cracking (FCC) catalysts, or both. This is evaluated on the basis of weight percent conversion of gas oil in a microactivity unit. The selectivity of FCC catalysts can be determined using Test Method D5154. 1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
||||||||||||
2. Referenced Documents | ||||||||||||
|
Historická
1.4.2007
Historická
1.4.2007
Historická
1.11.2011
Historická
1.10.2009
Historická
1.4.2012
Historická
1.4.2014
Poslední aktualizace: 26.11.2024 (Počet položek: 2 206 223)
© Copyright 2024 NORMSERVIS s.r.o.