Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
Standard Test Methods for Sorbent Performance of Absorbents (Withdrawn 2018)
Automaticky přeložený název:
Standardní zkušební metody pro Sorbentu výkonu Absorbenty
NORMA vydána dne 1.10.2009
Označení normy: ASTM F716-09
Poznámka: NEPLATNÁ
Datum vydání normy: 1.10.2009
Kód zboží: NS-56225
Počet stran: 6
Přibližná hmotnost: 18 g (0.04 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Keywords:
absorbents, adsorbents, oil, sorbent, sorbent performance, Absorbent materials/applications, Absorption, Buoyancy, Exterior exposure tests, Oil absorption, Penetration, Performance--oil spill control materials/systems, Release rates, Sorbents, Strength, Water analysis, ICS Number Code 71.040.30 (Chemical reagents)
Significance and Use | ||||||
These methods are to be used as a basis for comparison of absorbents in a consistent manner. These tests are not appropriate for adsorbent materials which are covered in Test Method F726. These methods are not useful for a comparison of absorbents with adsorbents, even though all absorbents exhibit adsorbent properties. Both types of materials have prime areas of utility. These methods may not list all the safety and disposal options necessary for safe ultimate disposal of used sorbent material into the environment. Federal, state, and local regulatory rules must be followed. |
||||||
1. Scope | ||||||
1.1 These test methods cover the development of laboratory test data which describe the performance of absorbent materials used to remove oils and other compatible fluids from water. 1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.3 This standard should be used to measure and describe the properties of materials, products, or assemblies in response to heat and flame under controlled laboratory conditions and should not be used to describe or appraise the fire hazard or fire risk of materials, products, or assemblies under actual fire conditions. However, results of this test may be used as elements of a fire risk assessment which takes into account all of the factors which are pertinent to an assessment of the fire hazard of a particular end use. (For a specific warning statement see 10.4.) |
||||||
2. Referenced Documents | ||||||
|
Historická
15.12.2008
Historická
1.4.2007
Historická
1.4.2007
Historická
1.11.2011
Historická
1.4.2012
Historická
1.4.2014
Poslední aktualizace: 26.11.2024 (Počet položek: 2 206 223)
© Copyright 2024 NORMSERVIS s.r.o.