Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
Standard Practice for Exposure of Metals and Alloys by Alternate Immersion in Neutral 3.5% Sodium Chloride Solution
Automaticky přeložený název:
Standardní praxe pro expozici kovů a slitin střídavým ponoření v neutrálních 3,5 % roztoku chloridu sodného
NORMA vydána dne 10.12.1999
Označení normy: ASTM G44-99
Poznámka: NEPLATNÁ
Datum vydání normy: 10.12.1999
Kód zboží: NS-57693
Počet stran: 4
Přibližná hmotnost: 12 g (0.03 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Keywords:
accelerated corrosion test, alternate immersion test, aluminum alloys, ferrous alloys, quality control test, sodium chloride solution, stress corrosion cracking, ICS Number Code 77.060 (Corrosion of metals)
1. Scope | ||||||||||||
1.1 This practice covers procedures for making alternate immersion stress corrosion tests in 3.5% sodium chloride (NaCl) (Note 1). It is primarily for tests of aluminum alloys (Test Method G47) and ferrous alloys, but may be used for other metals. It sets forth the environmental conditions of the test and the means for controlling them. Note 1-Alternate immersion stress corrosion exposures are sometimes made in substitute ocean water (without heavy metals) prepared in accordance with Specification D1141. The general requirements of this present practice are also applicable to such exposures except that the reagents used, the solution concentration, and the solution pH should be as specified in Specification D1141.1.2 This practice applies only to tests in which the specimens are accessible to the surrounding air under conditions that permit drying. It does not cover tests in which specimens are placed in closed containers into which the solution is periodically pumped and the specimens not permitted to dry. 1.3 This practice is intended for alloy development and for applications where the alternate immersion test is to serve as a control test on the quality of successive lots of the same material. Therefore, strict test conditions are stipulated for maximum assurance that variations in results are attributable to variations in the material being tested. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
||||||||||||
2. Referenced Documents | ||||||||||||
|
Poslední aktualizace: 23.12.2024 (Počet položek: 2 217 157)
© Copyright 2024 NORMSERVIS s.r.o.