Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
Standard Test Method for Evaporation Loss of Lubricating Greases and Oils
Automaticky přeložený název:
Standardní zkušební metoda pro odpařování Ztráta Mazací tuky a oleje
NORMA vydána dne 1.5.2008
Označení normy: ASTM D972-02(2008)
Poznámka: NEPLATNÁ
Datum vydání normy: 1.5.2008
Kód zboží: NS-39940
Počet stran: 4
Přibližná hmotnost: 12 g (0.03 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Keywords:
evaporation, grease, oil, oil bath, rotameter, volatiles, Evaporation loss, Lubricating grease, Lubricating oils, Oil baths, Rotameter applications/analysis, Volatility--petroleum products, ICS Number Code 75.100 (Lubricants, industrial oils and related products)
Significance and Use | ||||||||
The loss of volatile materials from greases and oils can adversely effect the original performance characteristics of a lubricant and therefore could be a significant factor in evaluating a lubricant for a specific use. Such volatiles can also be considered contaminants in the environment in which the lubricant is to be used. Correlation between results from this test method and service performance has not been established. The test can be run at any agreed upon temperature between 100 and 150°C (210 to 300°F). Note 1—The specified flow of air, 2.58 ± 0.02 g/min, (2 L/min at standard temperature and pressure), assumes dry air. It is not known that the original work involved dry air but it has since been shown that this can be a factor in reproducibility and should be addressed. A dew point of less than 10°C at standard temperature and pressure will be satisfactory. Note 2—To determine evaporation loss at temperatures above 150°C (300°F), see Test Methods D 2595. |
||||||||
1. Scope | ||||||||
1.1 This test method covers the determination of the loss in mass by evaporation of lubricating greases and oils for applications where evaporation loss is a factor. Evaporation loss data can be obtained at any temperature in the range from 100 to 150°C (210 to 300°F). 1.2 The values stated in SI units are to be regarded as standard. The values in given in parentheses are for information only. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
||||||||
2. Referenced Documents | ||||||||
|
Historická
1.10.2013
Historická
1.12.2012
Historická
1.5.2010
Historická
1.5.2008
Historická
1.5.2011
Historická
1.1.2014
Poslední aktualizace: 22.12.2024 (Počet položek: 2 217 000)
© Copyright 2024 NORMSERVIS s.r.o.