Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
Standard Test Method for Low-Temperature Torque of Ball Bearing Grease
Automaticky přeložený název:
Standardní zkušební metoda pro nízkoteplotní točivý moment ložiskové vazelíny
NORMA vydána dne 1.5.2011
Označení normy: ASTM D1478-11
Poznámka: NEPLATNÁ
Datum vydání normy: 1.5.2011
Kód zboží: NS-17389
Počet stran: 7
Přibližná hmotnost: 21 g (0.05 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Keywords:
ball bearing grease, ball bearing torque, low-temperature torque, lubricating grease, torque, Ball/roller bearings (lubricating grease), Low-temperature testing, Lubricating grease, Temperature tests--petroleum products, ICS Number Code 75.100 (Lubricants, industrial oils and related products)
Significance and Use | ||||||
This test method was developed using greases having very low torque characteristics at −54°C (−65°F). Specifications for greases of this type commonly require testing at this temperature. Specifications for greases of other types can require testing at temperatures from −75 to −20°C (−100 to 0°F). This test method has proved helpful in the selection of greases for low-powered mechanisms, such as instrument bearings used in aerospace applications. The suitability of this test method for other applications requiring different greases, speeds, and temperatures should be determined on an individual basis. Test Method D4693 may be better suited for applications using larger bearings or greater loads. However, greases having such characteristics that permit torque evaluations by either this test method or Test Method D4693 will not give the same values in the two test methods (even when converted to the same torque units) because the apparatus and test bearings are different. |
||||||
1. Scope | ||||||
1.1 This test method covers the determination of the extent to which a grease retards the rotation of a slow-speed ball bearing by measuring starting and running torques at low temperatures (below −20°C (0°F)). 1.1.1 Torque measurements are limited by the capacity of the torque-measuring equipment. Note 1—When initially developed, the original dynamometer scale limited the torque capacity to approximately 30 000 g·cm; the original dynamometer scale is obsolete, however. The suggested replacement scale has not been evaluated; it could extend the limit to approximately 75 000 g·cm. 1.2 The values stated in SI units are to be regarded as standard. The values given in parentheses are for information only. The exception is torque values that are given in cgs-metric units, which are universally used in grease specifications. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific hazard and warning statements, see 6.1.1, 7.2, 7.4, 8.7, and 8.11. |
||||||
2. Referenced Documents | ||||||
|
Historická
1.6.2011
Historická
1.12.2012
Historická
15.4.2012
Historická
1.10.2013
Historická
1.12.2012
Historická
1.5.2010
Poslední aktualizace: 22.11.2024 (Počet položek: 2 206 568)
© Copyright 2024 NORMSERVIS s.r.o.