Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
Standard Specification for Testing and Establishing Allowable Loads of Joist Hangers
Přeložit název
NORMA vydána dne 1.7.2021
Označení normy: ASTM D7147-21
Datum vydání normy: 1.7.2021
Kód zboží: NS-1031159
Počet stran: 11
Přibližná hmotnost: 33 g (0.07 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
This specification covers a procedure for evaluating metal devices used for wood-to-wood, wood-to-concrete, wood-to-concrete masonry, and wood-to-steel joist, beam, and girder connections. It describes test methods for evaluating the capacities of joist hangers subject to vertical and torsional loading. Also, this specification provides a method of assigning allowable loads to joist hangers based on measured strength and deformation characteristics. Test specimens consisting of a length of joist supported by joist hangers attached to two headers are subjected to a vertical load by a suitable testing machine, while the vertical load and corresponding deflection of the joist are measured and recorded to provide load-slip data.
Keywords:
connections, connectors, connectors for wood, hangers, hanger allowable loads, hanger capacities, hanger test, hanger testing, joist hangers, metal connectors, structural connectors, wood connections, wood connectors, wood to wood connectors,, ICS Number Code 91.190 (Building accessories)
1. Scope | ||||||||||||||||||||||||||||||||||
1.1?This specification covers a procedure for evaluating metal devices used for wood-to-wood, wood-to-concrete, wood-to-concrete masonry, and wood-to-steel connections. This method is intended for use with devices used to connect joists, beams, and girders together. These devices are commonly described as joist hangers. 1.2?This specification describes test methods for evaluating the capacities of joist hangers subject to vertical and torsional loading. 1.3?This specification provides a method of assigning allowable loads to joist hangers based on measured strength and deformation characteristics. Information obtained by the provisions of this specification is applicable to design when using the Allowable Stress Design method. 1.4?UnitsThe values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard. 1.5?This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.6?This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
||||||||||||||||||||||||||||||||||
2. Referenced Documents | ||||||||||||||||||||||||||||||||||
|
Chcete pravidelně odebírat informace o nově vycházejících normách z celého světa a to zcela zdarma?
Přihlašte se k odběru. Vše je velice jednoduché a absolutně ZDARMA.
Na výběr máte vydavatele z celého světa.
Poslední aktualizace: 12.05.2025 (Počet položek: 2 199 201)
© Copyright 2025 NORMSERVIS s.r.o.