Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
Standard Practice for Inclusion of Precision Statement Variation in Specification Limits
Automaticky přeložený název:
Standardní praxe pro začleňování Precision prohlášení variace v Limits Specifikace
NORMA vydána dne 1.12.2009
Označení normy: ASTM D6607-00(2009)
Poznámka: NEPLATNÁ
Datum vydání normy: 1.12.2009
Kód zboží: NS-35853
Počet stran: 3
Přibližná hmotnost: 9 g (0.02 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Keywords:
Precision, Specification preparation, Inclusion (of precision statement variation), Pavement surfaces--specifications, ICS Number Code 19.020 (Test conditions and procedures in general)
Significance and Use | ||||||||||||
Each test method has a limited precision. Even if a test is performed as carefully and as correctly as possible on a material which is as homogeneous as can be obtained, the test will still vary from one to another. A widely used measure of the variation of the test results from a test method is the standard deviation (σ). In an ASTM standard test, the standard deviation of the test method can be found in the Precision and Bias statement for the test. The “Blue Book,” Form and Style for ASTM Standards, requires that all test methods include Precision and Bias statements. Practice C670 and Practice C802 provide guidance for determination of these values. If the precision of a test method is low and the precision of the test has not been properly considered in a material specification, a uniform material with the right quality may still be rejected most of the time because of the wide variation of the test results. In order to have rational specification limits, the precision of the test used should be properly included in a specification. This practice provides a guideline for proper inclusion of precision of the test method in a rational specification. |
||||||||||||
1. Scope | ||||||||||||
1.1 This practice covers a method of determining rational specification limits by inclusion of the precision of the test method used in the specification. 1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
||||||||||||
2. Referenced Documents | ||||||||||||
|
Chcete mít jistotu o platnosti užívaných předpisů?
Nabízíme Vám řešení, abyste mohli používat stále platné (aktuální) legislativní předpisy.
Chcete vědět více informací? Podívejte se na tuto stránku.
Poslední aktualizace: 22.12.2024 (Počet položek: 2 217 000)
© Copyright 2024 NORMSERVIS s.r.o.