Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
Standard Test Method for Bulk Specific Gravity and Density of Non-Absorptive Compacted Bituminous Mixtures
Automaticky přeložený název:
Standardní zkušební metoda pro hromadné Měrná hmotnost a hustota Non- absorpčních zhutněné asfaltové směsi
NORMA vydána dne 1.12.2011
Označení normy: ASTM D2726-11
Poznámka: NEPLATNÁ
Datum vydání normy: 1.12.2011
Kód zboží: NS-21321
Počet stran: 4
Přibližná hmotnost: 12 g (0.03 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Keywords:
air voids, compaction, density, specific gravity, unit weight, Air voids, Bituminous paving mixtures (compacted), Bulk specific gravity, Density--paving materials, Nonabsorptive bituminous mixtures, Saturated surface-dry specimens, Specific gravity--bituminous mixtures, ICS Number Code 91.100.50 (Binders. Sealing materials), 93.080.20 (Road construction materials)
Significance and Use | ||||||||||||||||||
The results obtained from this test method can be used to determine the unit weight of compacted dense bituminous mixtures and in conjunction with Test Method D3203, to obtain percent air voids. These values in turn may be used in determining the relative degree of compaction. Since specific gravity has no units, it must be converted to density in order to do calculations that require units. This conversion is made by multiplying the specific gravity at a given temperature by the density of water at the same temperature. Note 1—The personnel and equipment used in performing this test can be evaluated in accordance with Practice D3666. |
||||||||||||||||||
1. Scope | ||||||||||||||||||
1.1 This test method covers the determination of bulk specific gravity and density of specimens of compacted bituminous mixtures. 1.2 This test method should not be used with samples that contain open or interconnecting voids or absorb more than 2 % of water by volume, or both, as determined in 10.3. 1.3 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
||||||||||||||||||
2. Referenced Documents | ||||||||||||||||||
|
Poslední aktualizace: 22.11.2024 (Počet položek: 2 206 568)
© Copyright 2024 NORMSERVIS s.r.o.