Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
Test Method for Determining Open Assembly Time of Carpet Mastic Adhesives
Automaticky přeložený název:
Zkušební metoda pro stanovení Otevřená doba montáže koberců tmelu lepidel
NORMA vydána dne 1.1.2011
Označení normy: ASTM D6325-98(2011)
Poznámka: NEPLATNÁ
Datum vydání normy: 1.1.2011
Kód zboží: NS-34677
Počet stran: 2
Přibližná hmotnost: 6 g (0.01 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Keywords:
adhesive, adhesion, carpet, open assembly time, Adhesives, Assembly time, Carpet adhesives, Mastic adhesives, Open assembly time, ICS Number Code 83.180 (Adhesives), 97.150 (Floor coverings)
Significance and Use | ||||||
The ability to have a sufficient open assembly time is critical when bonding a carpet. An adhesive with too short an open assembly time will not allow the installer enough time to position the carpet before the adhesive is dried beyond use. A product with too long an open assembly time will not provide enough dry time for the carpet to bond to the intended substrate without movement of the carpet. The test method provides a means of measuring the open assembly time for an adhesive. Use of such a test method can aid both the manufacturer to develop and the user to select the appropriate adhesive for the installation of carpet. Test Method C679 was used as a model for this test method. |
||||||
1. Scope | ||||||
1.1 This test method describes a procedure to measure open assembly time for a troweled carpet adhesive. 1.2 This test method provides an evaluation of the ability of an adhesive to effectively wet out the intended carpet backing. 1.3 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
||||||
2. Referenced Documents | ||||||
|
Historická
1.8.2012
Historická
1.7.2012
Historická
1.10.2011
Historická
15.4.2013
Historická
1.7.2012
Historická
1.3.2009
Poslední aktualizace: 22.11.2024 (Počet položek: 2 206 568)
© Copyright 2024 NORMSERVIS s.r.o.