Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
Standard Test Method for Tuft Element Length of Uncoated Pile Yarn Floor Coverings
Automaticky přeložený název:
Standardní zkušební metoda pro Tuft Element Délka Nenatíraná Pile příze podlahových krytin
NORMA vydána dne 1.2.2012
Označení normy: ASTM D6283-12
Poznámka: NEPLATNÁ
Datum vydání normy: 1.2.2012
Kód zboží: NS-34516
Počet stran: 4
Přibližná hmotnost: 12 g (0.03 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Keywords:
carpet, pile yarn floor covering, textile floor covering, Carpets, Pile yarn floor coverings, Textile floor covering materials, Tuft element length, Uncoated pile yarn floor covering, ICS Number Code 97.150 (Floor coverings)
Significance and Use | ||||||||||
The determination of the tuft length of pile yarn floor covering is useful in quality and cost control during the manufacture of pile yarn floor covering. Both appearance and performance can be affected by changes in this characteristic. In case there are disputable differences between reported test results for two or more laboratories, comparative tests should be performed to determine if there is a statistical bias between them, using competent statistical assistance. At a minimum, test samples should be used that are as homogeneous as possible, that are drawn from the material from which disputable test results were obtained, and that are assigned randomly in equal numbers to each laboratory for testing. The test results from the two laboratories should be compared using a statistical test for unpaired data, at a probability level chosen prior to the testing series. If a bias is found, either its cause must be found and corrected, or future test results must be adjusted in consideration of the known bias. |
||||||||||
1. Scope | ||||||||||
1.1 This test method covers the measurement of tuft length and pile yarn length of uncoated pile floor coverings. 1.2 Usually the tuft elements measured as directed in this test method will each be bound at only one binding site, but this test method also may be used for tuft elements bound at more than one binding site, provided that every tuft element measured is bound at the same number of binding sites. 1.3 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard. 1.4 This practice does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this practice to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
|
||||||||||
2. Referenced Documents | ||||||||||
|
Historická
1.10.2011
Historická
15.4.2013
Historická
1.7.2012
Historická
1.3.2009
Historická
15.9.2011
Historická
1.8.2011
Chcete mít jistotu, že používáte pouze platné technické normy?
Nabízíme Vám řešení, které Vám zajistí měsíční přehled o aktuálnosti norem, které používáte.
Chcete vědět více informací? Podívejte se na tuto stránku.
Poslední aktualizace: 22.11.2024 (Počet položek: 2 206 568)
© Copyright 2024 NORMSERVIS s.r.o.