Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
Standard Test Method for Measuring the Filtration Compatibility of Soil-Geotextile Systems
Automaticky přeložený název:
Standardní zkušební metoda pro měření filtraci Kompatibilita s podložím geotextilie Systems
NORMA vydána dne 1.7.2012
Označení normy: ASTM D5101-12
Poznámka: NEPLATNÁ
Datum vydání normy: 1.7.2012
Kód zboží: NS-29844
Počet stran: 8
Přibližná hmotnost: 24 g (0.05 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Keywords:
clogging potential, gradient ratio, soil-geotextile system, ICS Number Code 59.080.70 (Geotextiles)
Significance and Use | ||||||||||||||||||||||||||||||||||||||||
This test method is recommended for the evaluation of the performance of water-saturated soil-geotextile systems under unidirectional flow conditions. The results obtained may be used as an indication of the compatibility of the soil-geotextile system with respect to both particle retention and flow capacity. This test method is intended to evaluate the performance of specific on-site soils and geotextiles at the design stage of a project, or to provide qualitative data that may help identify causes of failure (that is, clogging, particle loss). It is not appropriate for acceptance testing of geotextiles. It is also improper to utilize the results from this test for job specifications or manufacturers' certifications. This test method is intended for site-specific investigation therefore is not an index property of the geotextile, and thus is not intended to be requested of the manufacturer or supplier of the geotextile. |
||||||||||||||||||||||||||||||||||||||||
1. Scope | ||||||||||||||||||||||||||||||||||||||||
1.1 This test method covers performance tests applicable for determining the compatibility of geotextiles with various types of water-saturated soils under unidirectional flow conditions. 1.2 Two evaluation methods may be used to investigate soil – geotextile filtration behavior, depending on the soil type: 1.2.1 For soils with a plasticity index lower than 5, the systems compatibility shall be evaluated per this standard. 1.2.2 For soils with a plasticity index of 5 or more, it is recommended to use ASTM D5567 (‘HCR’, Hydraulic Conductivity Ratio) instead of this test method. 1.2.3 If the plasticity index of the soil is close to 5, the involved parties shall agree on the selection of the appropriate method prior to conducting the test. This task may require comparison of the permeability of the soil-geotextile system to the detection limits of the HCR and Gradient Ratio Test (GRT) test apparatus being used. 1.3 The values stated in SI units are to be regarded as standard. The values in parentheses are for information only. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
||||||||||||||||||||||||||||||||||||||||
2. Referenced Documents | ||||||||||||||||||||||||||||||||||||||||
|
Historická
1.6.2011
Historická
1.1.2012
Historická
1.7.2012
Historická
1.7.2012
Historická
1.1.2012
Historická
15.7.2012
Poslední aktualizace: 04.11.2024 (Počet položek: 2 209 323)
© Copyright 2024 NORMSERVIS s.r.o.