Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
Standard Test Method for Puncture-Propagation Tear Resistance of Plastic Film and Thin Sheeting
Automaticky přeložený název:
Standardní zkušební metoda pro proražení šíření odolnost proti roztržení plastové fólie a Thin Pažení
NORMA vydána dne 1.5.2009
Označení normy: ASTM D2582-09
Poznámka: NEPLATNÁ
Datum vydání normy: 1.5.2009
Kód zboží: NS-20813
Počet stran: 5
Přibližná hmotnost: 15 g (0.03 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Keywords:
plastic film, plastic sheeting, puncture propagation, slit tear, snagging, tear resistance, ´V´ tear, Plastic sheet and film--tear resistance, Tear resistance, ICS Number Code 83.140.10 (Films and sheets)
Significance and Use | ||||||||||||
The puncture-propagation of tear test measures the resistance of a material to snagging, or more precisely, to dynamic puncture and propagation of that puncture resulting in a tear. Failures due to snagging occur in a variety of end uses, including industrial bags, liners, and tarpaulins. The units reported in this test method are Newtons (tear resistance). Experience has shown that for many materials puncture does not contribute significantly to the force value determined, due to the sharpness of the propagating probe used. However, comparing the results of prepunctured test specimens with normal nonpunctured specimens will give an indication of the extent of any puncture resistance in the reported result. For many materials, there may be a specification that requires the use of this test method, but with some procedural modifications that take precedence when adhering to the specification. Therefore, it is advisable to refer to that material specification before using this test method. Table 1 of Classification System D 4000 lists the current ASTM materials standards. |
||||||||||||
1. Scope | ||||||||||||
1.1 This test method covers the determination of the dynamic tear resistance of plastic film and thin sheeting subjected to end-use snagging-type hazards. 1.2 The values stated in SI units are to be regarded as the standard. The values given in parentheses are for information only. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Note 1—Film has been arbitrarily defined as sheeting having nominal thickness not greater than 0.25 μm (0.010 in.). Note 2—There is no equivalent ISO test method. |
||||||||||||
2. Referenced Documents | ||||||||||||
|
Historická
1.6.2011
Historická
1.2.2011
Historická
15.4.2009
Historická
1.4.2011
Historická
1.4.2013
Historická
1.4.2010
Poslední aktualizace: 03.05.2024 (Počet položek: 2 896 946)
© Copyright 2024 NORMSERVIS s.r.o.