Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
Standard Guide for Determination of Thickness of Plastic Film Test Specimens
Automaticky přeložený název:
Standardní vodítko pro stanovení tloušťky plastové fólie zkušebních vzorků
NORMA vydána dne 1.4.2013
Označení normy: ASTM D6988-13
Poznámka: NEPLATNÁ
Datum vydání normy: 1.4.2013
Kód zboží: NS-37228
Počet stran: 7
Přibližná hmotnost: 21 g (0.05 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Keywords:
dial gauge, dimensions, film, plastics, thickness, ICS Number Code 83.140.10 (Films and sheets)
Significance and Use | ||||||||||
5.1 This guide is intended to provide recommendations and suggested good practices to determine precise dimensions when necessary for the calculation of properties expressed in physical units. It is not intended to replace practical thickness measurements based on commercial portable tools, nor is it implied that thickness measurements made by the procedures will agree exactly. |
||||||||||
1. Scope | ||||||||||
1.1 This guide covers the determination of the thickness of plastic films where the thickness is used directly in determining the results of tests for various properties. Use this practice except as otherwise required in material specifications or in applicable test standards. 1.2 The values stated in SI units
are to be regarded as the standard.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory requirements prior to use.
|
|
Standard Practice for Cutting Film and Sheeting Test Specimens
|
ISO 472
|
Plastics--Vocabulary Available from American National Standards Institute (ANSI), 25 W. 43rd St., 4th Floor, New York, NY 10036.
|
|
Standard Practice for Conditioning Plastics for Testing
|
|
Standard Terminology Relating to Plastics
|
|
Standard Test Methods for Physical Dimensions of Solid Plastics Specimens |
Poslední aktualizace: 22.11.2024 (Počet položek: 2 206 568)
© Copyright 2024 NORMSERVIS s.r.o.