Cookies
Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
ASTM D1574-22
Standard Test Method for Extractable Matter in Wool and Other Animal Fibers
Přeložit název
NORMA vydána dne 1.6.2022
Informace o normě:
Označení normy: ASTM D1574-22
Datum vydání normy: 1.6.2022
Kód zboží: NS-1066638
Počet stran: 5
Přibližná hmotnost: 15 g (0.03 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Anotace textu normy ASTM D1574-22 :
Keywords:
extractable matter, wool,
Doplňující informace
| Significance and Use | ||||||||||||||||
|
5.1?Test Method D1574 is considered satisfactory for acceptance testing since the method has been used extensively in the trade for acceptance testing. 5.1.1?In case of a dispute arising from differences in reported test results when using Test Method D1574 for acceptance testing of commercial shipments, the purchaser and the supplier should conduct comparative tests to determine if there is a statistical bias between their laboratories. Competent statistical assistance is recommended for the investigation of bias. As a minimum, the two parties should take a group of test specimens that are as homogeneous as possible and that are from a lot of material of the type in question. The test specimens should then be randomly assigned in equal numbers to each laboratory for testing. The average results from the two laboratories should be compared using Student's t-test for unpaired data and an acceptable probability level chosen by the two parties before the testing is begun. If a bias is found, either its cause must be found and corrected or the purchaser and the supplier must agree to interpret future test results in the light of the known bias. 5.2?This test method may be used to estimate the quantity of oil, grease, and waxy materials remaining on or in wool fibers after scouring, or the quantity of lubricant added before carding or remaining after carding, or the quantity of such materials added or removed in subsequent processing operations. 5.3?The residues obtained in this test may be subjected to chemical analysis for identification and assay of the component materials, if desired. 5.4?The specified solvent in this test method does not remove some materials, such as soaps, that may be present in wool and hence in some cases may reflect more closely the added content of some extractables in wool such as oils. When such materials are present and an estimate of their quantity is desired, some other solvent or combination of solvents should be used as specified in a material specification or by agreement. The information in the Annex of this test method may be useful for this purpose. Various solvents have been used in the past, and are still used to some extent. Many of these solvents are undesirable, however, because of flammability, toxic or anesthetic effects, or unpleasant odors. Trichlorotrifluoroethane is nonflammable, has a very low level of toxicity, and a high degree of stability and is a good solvent for most fatty or mineral oils, greases, and waxes. The specified solvent, under conditions of the test, was found in interlaboratory test not to extract wool protein. Note 2:?Since the specified solvent is primarily a solvent for
oils rather than soap, the extractable matter obtained in this
procedure may be considered a measure of commercial oil
content.
Note 3:?Due to the hazardous nature of some of the solvents
listed in Table A1.1, the
user should refer to the manufacturer's recommendations for use
before using under the conditions of this test method.
|
||||||||||||||||
| 1. Scope | ||||||||||||||||
|
1.1?This test method covers the determination of the amount of extractable matter in samples of all forms of wool, except grease wool, that is extractable with a non-flammable vapor degreasing and cleaning solvent. 1.2?This test method does not cover the determination of the amounts of different components in the extracted matter nor their identification. 1.3?This test method is suitable for use with other animal fibers. Note 1:?The determination of extractable matter in yarns and
in felts is covered in Test Methods D2257 and D461. For the determination of
alcohol-extractable matter in oven-dry scoured wool, refer to Test
Methods D584 and D1334.
1.4?The values stated in SI units are to be regarded as standard. The values given in parentheses after SI units are provided for information only and are not considered standard. 1.5?This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.6?This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
||||||||||||||||
| 2. Referenced Documents | ||||||||||||||||
|
Odebírejte informace o nově vydaných normách ZDARMA:
Chcete pravidelně odebírat informace o nově vycházejících normách z celého světa a to zcela zdarma?
Přihlašte se k odběru. Vše je velice jednoduché a absolutně ZDARMA.
Na výběr máte vydavatele z celého světa.
