Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
Standard Test Method for Wool Content of Raw Wool´Commercial Scale
Přeložit název
NORMA vydána dne 1.7.2018
Označení normy: ASTM D1334-18
Datum vydání normy: 1.7.2018
Kód zboží: NS-856833
Počet stran: 3
Přibližná hmotnost: 9 g (0.02 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Keywords:
content, wool,, ICS Number Code 59.060.10 (Natural fibres)
Significance and Use | ||||||||||||
5.1 This test method is considered satisfactory for use as a referee method for the determination of the wool base content and the clean wool fiber present in a lot of raw wool. If there are differences of practical significance between reported test results for two laboratories (or more), comparative test should be performed to determine if there is a statistical bias between them, using competent statistical assistance. As a minimum, use the samples for such a comparative test that are as homogenous as possible, drawn from the same lot of material as the samples that resulted in the disparate results during the initial testing and randomly assigned in equal numbers to each laboratory. The test results from the laboratories involved should be compared using a statistical test for unpaired data, probability level chosen prior to the testing series. If bias is found, either its cause must be found and corrected, or future results for that material be adjusted in consideration of the known bias. 5.2 This test method is also used in studies aimed at deriving suitable formulas for estimating the allowances to be made for wool unavoidably lost or destroyed in such commercial operations as carding, combing, or carbonizing. |
||||||||||||
1. Scope | ||||||||||||
1.1 This test method covers the determination of the wool base content and the clean wool fiber present in a lot of raw wool by commercial-scale scouring of the lot followed by laboratory tests on samples of the scoured wool. Note 1: The sampling of lots of raw wool in packages is
covered in Practice D1060,
and the determination of the wool content of such samples is
covered in Test Method D584.
The determination of vegetable matter and other alkali-insoluble
impurities in scoured wool is covered in Test Method D1113. For factors for the conversion of
wool base content to its equivalent in terms of scoured wool, top,
or noil of various commercially specified compositions, refer to
Practice D2720.
Note 2: The values stated in U.S. Customary Units are to be
regarded as the standard because of common commercial practice. The
S.I. units in parentheses are provided for information
only.
Note 3: Because of trade practice the term “weight” is used in
this test method instead of the technically correct term
“mass”.
1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
||||||||||||
2. Referenced Documents | ||||||||||||
|
Poslední aktualizace: 01.11.2024 (Počet položek: 2 208 817)
© Copyright 2024 NORMSERVIS s.r.o.