Cookies
Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
ASTM C1126-10
Standard Specification for Faced or Unfaced Rigid Cellular Phenolic Thermal Insulation
Automaticky přeložený název:
Standardní specifikace pro potažené nebo unfaced tuhého, z buněk fenolických Tepelná izolace
NORMA vydána dne 1.9.2010
Informace o normě:
Označení normy: ASTM C1126-10
Poznámka: NEPLATNÁ
Datum vydání normy: 1.9.2010
Kód zboží: NS-9611
Počet stran: 6
Přibližná hmotnost: 18 g (0.04 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Anotace textu normy ASTM C1126-10 :
Keywords:
cellular phenolic thermal insulation, faced phenolic foam thermal insulation, phenolic foam thermal insulation, rigid thermal insulation, unfaced phenolic foam thermal insulation, Block and board thermal insulation--specifications, Faced thermal insulation--specifications, Pipe thermal insulation--specifications, Rigid thermal insulation--specifications, Roof insulation--specifications, Thermal insulating materials--specifications, Unfaced thermal insulation--specifications
Doplňující informace
| 1. Scope | ||||||||||||||||||||||||||||||||||||||||||
|
1.1 This specification covers faced or unfaced, rigid cellular phenolic thermal insulation. Boards shall be faced or unfaced. Tubular forms covered by this standard shall be unfaced. It does not apply to field expanded cellular phenolic materials. Note 1—If a facer or vapor retarder is to be used for the tubular form, then refer to Practice C921 1.2 Materials covered by this specification are used as roof insulation; sheathing or rigid board for non-load bearing, building material applications; and pipe insulation for use between −40 and 257°F (−40 and 125°C). Type II Grade 1 and Type III Grade 1 materials with an appropriate vapor retarder covering on the warm surface can be used to a lower temperature limit of −290°F (−180°C). (See 7.2.) 1.3 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard. 1.4 The main body of this specification covers Chlorofluorocarbons and Hydrochlorofluorocarbons free (ODP 0) closed cell rigid cellular phenolic thermal insulation. 1.5 The table in Annex A1 addresses requirements of faced and unfaced rigid cellular phenolic thermal insulation manufactured with Hydrochlorofluorocarbons blowing agent. 1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific precautionary statements, see Section 16. |
||||||||||||||||||||||||||||||||||||||||||
| 2. Referenced Documents | ||||||||||||||||||||||||||||||||||||||||||
|
Doporučujeme:
