Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
Standard Specification for Hot-Rolled and/or Cold-Finished Hafnium Rod and Wire
Automaticky přeložený název:
Standardní Specifikace pro válcované za tepla a / nebo za studena dokončenou hafnium a dráty
NORMA vydána dne 1.5.2015
Označení normy: ASTM B737-10(2015)
Poznámka: NEPLATNÁ
Datum vydání normy: 1.5.2015
Kód zboží: NS-587565
Počet stran: 4
Přibližná hmotnost: 12 g (0.03 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Keywords:
hafnium, hafnium alloy, rod, wire,, ICS Number Code 77.150.99 (Other products of non-ferrous metals)
Significance and Use | ||||||||
15.1 For the purpose of determining compliance with the specified limits for requirements of the properties listed in the following table, an observed value or a calculated value shall be rounded as indicated in accordance with the rounding methods of Practice E29.
|
||||||||
1. Scope | ||||||||
1.1 This specification covers hot- or cold-worked hafnium rod and wire. 1.2 This specification contains two material grades, one specifically for nuclear applications (Grade R1) and one for commercial alloying applications (Grade R3). 1.3 The products covered include the following: 1.3.1 Rod 3/8 to 1 in. (9.5 to 25 mm) in diameter. 1.3.2 Wire less than 3/8 in. (9.5 mm) in diameter. 1.4 Unless a single unit is used, for example, corrosion mass gain in mg/dm2, the values stated in either inch-pound or SI units are to be regarded separately as standard. The values stated in each system are not exact equivalents; therefore, each system must be used independently of the other. SI values cannot be mixed with inch-pound values. 1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
||||||||
2. Referenced Documents | ||||||||
|
Chcete mít jistotu, že používáte pouze platné technické normy?
Nabízíme Vám řešení, které Vám zajistí měsíční přehled o aktuálnosti norem, které používáte.
Chcete vědět více informací? Podívejte se na tuto stránku.
Poslední aktualizace: 26.04.2024 (Počet položek: 2 896 057)
© Copyright 2024 NORMSERVIS s.r.o.