Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
Standard Specification for Nickel-Iron-Chromium-Molybdenum Alloy Rod
Přeložit název
NORMA vydána dne 1.11.2021
Označení normy: ASTM B621-21
Datum vydání normy: 1.11.2021
Kód zboží: NS-1044287
Počet stran: 4
Přibližná hmotnost: 12 g (0.03 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
This specification covers nickel-iron chromium-molybdenum alloy (UNS N08320) rod for use in general corrosive service. The rods are classified according to their sizes. The material shall conform to the composition limits specified. Chemical analysis and tension test shall be made to conform to the specified requirements.
Keywords:
rod, UNS N08320,, ICS Number Code 77.150.40 (Nickel and chromium products)
1. Scope | ||||||||||
1.1?This specification1.2?The following products are covered under this specification: 1.2.1?Rods 5/16?to 3/4?in. (7.94 to 19.05 mm) excl in diameter, hot or cold finished, solution annealed and pickled or mechanically descaled. 1.2.2?Rods 3/4?to 31/2?in. (19.05 to 88.9 mm) incl in diameter, hot or cold finished, solution annealed, ground or turned. 1.3?The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard. 1.4?This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to become familiar with all hazards including those identified in the appropriate Safety Data Sheet (SDS) for this product/material as provided by the manufacturer, to establish appropriate safety, health, and environmental practices, and determine the applicability of regulatory limitations prior to use. 1.5?This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
||||||||||
2. Referenced Documents | ||||||||||
|
Poslední aktualizace: 11.09.2024 (Počet položek: 2 346 290)
© Copyright 2024 NORMSERVIS s.r.o.