Cookies
Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
ASTM B596-21
Standard Specification for Gold-Copper Alloy Electrical Contact Material
Přeložit název
NORMA vydána dne 1.11.2021
Informace o normě:
Označení normy: ASTM B596-21
Datum vydání normy: 1.11.2021
Kód zboží: NS-1043734
Počet stran: 3
Přibližná hmotnost: 9 g (0.02 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Kategorie - podobné normy:
Anotace textu normy ASTM B596-21 :
This specification covers wrought gold-copper alloy in the form of wire, rod, strip, and tubing to be used for electrical contacts. Raw materials shall be of such quality and purity that the finished product (produced by cold working, heat treating, annealing, turning, grinding, and/or pickling as required) will have the properties and characteristics prescribed in this specification. The material shall meet the requirements of chemical composition specified for gold, copper, noble metal impurities, and other impurities. Ultimate tensile strength, elongation, microhardness (Knoop or Vickers), hardness (Rockwell or Rockwell Superficial), or a combination of these mechanical properties may be specified as the temper criterion. Annealed and hard drawn wires, strips, and tubings, within the prescribed diameter or thickness, shall conform to the specified tensile strength, elongation, and hardness. The following tests shall be performed: Knoop hardness test, tension test, chemical analysis such as spectrochemical or wet analysis, and stress corrosion crack test by immersion test, compression, and bending.
Keywords:
coin gold, contacts, electrical contacts, gold alloy, low contact resistance, low energy contact, non arcing contact,, ICS Number Code 77.120.99 (Other non-ferrous metals and their alloys)
Doplňující informace
| 1. Scope | ||||||
|
1.1?This specification covers a wrought alloy containing gold and copper in the form of wire, rod, strip, and tubing for electrical contacts. 1.2?The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard. 1.3?The following precautionary statement pertains to the test method portion only, Section 7, of this standard: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to become familiar with all hazards including those identified in the appropriate Safety Data Sheet (SDS) for this product/material as provided by the manufacturer, to establish appropriate safety, health, and environmental practices, and determine the applicability of regulatory limitations prior to use. 1.4?This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
||||||
| 2. Referenced Documents | ||||||
|
Odebírejte informace o nově vydaných normách ZDARMA:
Chcete pravidelně odebírat informace o nově vycházejících normách z celého světa a to zcela zdarma?
Přihlašte se k odběru. Vše je velice jednoduché a absolutně ZDARMA.
Na výběr máte vydavatele z celého světa.
