Cookies
Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
ASTM B403-20
Standard Specification for Magnesium-Alloy Investment Castings
Přeložit název
NORMA vydána dne 1.11.2020
Informace o normě:
Označení normy: ASTM B403-20
Datum vydání normy: 1.11.2020
Kód zboží: NS-1012985
Počet stran: 4
Přibližná hmotnost: 12 g (0.03 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Kategorie - podobné normy:
Anotace textu normy ASTM B403-20 :
This specification covers magnesium-alloy investment castings designated as AM100A, AZ81A, AZ91C, AZ91E, AZ92A, EQ21A, EZ33A, K1A, QE22A, ZE41A, and ZK61A. Sufficient stock shall be allowed for shrinkage and, where required, for finishing; but castings of excessive weight shall not be furnished. The castings shall conform to the chemical composition requirements prescribed for magnesium, aluminum, manganese, zinc, zirconium, rare earth elements, copper, nickel, silicon, iron, and other impurities, as determined by chemical analysis, and shall meet the specified requirements for the tensile properties such as tensile strength, yield strength, and elongation. Requirements for heat treatment and tensile test are detailed. The castings shall be of uniform quality and condition, free from cracks and other injurious defects, shall be cleaned before inspection by blasting or other approved process, and shall not be repaired by welding, impregnation, peening, or other method unless it is required.
Keywords:
investment castings, magnesium alloy,, ICS Number Code 77.150.20 (Magnesium products)
Doplňující informace
| 1. Scope | ||||||||||||||||||||||||||||||||||
|
1.1?This specification covers magnesium-alloy investment castings designated as shown in Table 1. 1.2?Alloy designations are in accordance with Practice E527; temper designations are in accordance with Practice B296. 1.3?The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard. 1.4?This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
||||||||||||||||||||||||||||||||||
| 2. Referenced Documents | ||||||||||||||||||||||||||||||||||
|
Doporučujeme:
