Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
Standard Specification for Tough-Pitch Fire-Refined Copper-Refinery Shapes
Automaticky přeložený název:
Standard Specification pro Tough-Pitch Fire-rafinované mědi rafinerií tvarů
NORMA vydána dne 1.10.2010
Označení normy: ASTM B216-10
Poznámka: NEPLATNÁ
Datum vydání normy: 1.10.2010
Kód zboží: NS-5772
Počet stran: 6
Přibližná hmotnost: 18 g (0.04 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Keywords:
fire refined copper, refinery shapes, tough pitch copper, Copper (refined/refinery shapes)--specifications, Tough pitch coppers, UNS C12500 (fire-refined tough pitch copper, FRTP), UNS C14200 (phosphorus deoxidized copper, arsenical (DPA)), UNS C14500 (phosphorus deoxidized copper, tellurium bearing), ICS Number Code 77.150.30 (Copper products)
Significance and Use | ||||||||||||||
Calculated values shall be rounded to the nearest unit in the last right-hand significant digit used in expressing the limiting value in accordance with the rounding method in Practice E29. |
||||||||||||||
1. Scope | ||||||||||||||
1.1 This specification establishes the requirements for tough-pitch fire-refined copper wire bars, cakes, slabs, and billets for fabricating into wrought products and ingot and ingot bars for use in the manufacture of copper and copper alloy castings. This copper is not intended for electrical purposes. 1.2 Copper under this specification corresponds to the designation “FRTP” (UNS C12500) as shown in Classification B224. This copper may also be used to produce copper, corresponding to the designation “DPTE” (UNS C14520). 1.3 Although this specification includes certain UNS designations as described in Practice E527, these designations are for cross reference only and are not specification requirements. Therefore, in case of conflict, this ASTM specification shall govern. 1.4 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard. 1.5 The following safety hazard caveat pertains only to the test method described in the annex of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. A1.1.1 This test method covers the analysis of antimony, arsenic, bismuth, lead, nickel, selenium, and tellurium in tough-pitch fire-refined copper. A1.1.2 This standard may involve hazardous materials, operations, and equipment. This standard does not purport to address all of the safety concerns associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
||||||||||||||
2. Referenced Documents | ||||||||||||||
|
Historická
1.4.2012
Historická
1.10.2013
Historická
15.2.2011
Historická
1.10.2010
Historická
1.10.2011
Historická
15.8.2009
Poslední aktualizace: 03.11.2024 (Počet položek: 2 209 203)
© Copyright 2024 NORMSERVIS s.r.o.