Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
Standard Specification for Oxygen-Free Electrolytic Copper-Refinery Shapes (Includes all amendments And changes 10/20/2015).
Automaticky přeložený název:
Standard Specification pro Oxygen-Free elektrolytické mědi rafinerií tvarů
NORMA vydána dne 1.4.2010
Označení normy: ASTM B170-99(2010)e1
Poznámka: NEPLATNÁ
Datum vydání normy: 1.4.2010
Kód zboží: NS-5581
Počet stran: 10
Přibližná hmotnost: 30 g (0.07 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Keywords:
billets, cakes, oxygen free, refinery shapes, silver containing, wire bars, Antimony content, Arsenic content, Bismuth content, Cadmium content, Calibration--metals/alloys analysis instrumentation, Combustion, Composition analysis--metals/alloys, Copper (refined/refinery shapes)--specifications, Embrittlement, Inert gas fusion, Infrared (IR) analysis--metals/alloys, Iron content--copper, Lead content--metals, Manganese content--Cu/Cu alloys, Mercury, Nickel content--miscellaneous metals/alloys
1. Scope | ||||||||||||||||||||||
1.1 This specification establishes the requirements for two grades of oxygen-free electrolytic copper wire bars, billets, and cakes produced without the use of metallic or metaloidal deoxidizers. 1.2 Oxygen-free copper, as described herein, is defined as copper containing oxygen not in excess of 0.0010 % (10 ppm). 1.2.1 Grade 1 copper (UNS C10100) corresponds to the designation OFE in Classification B224. 1.2.2 Grade 2 copper (UNS C10200) corresponds to the designation OF in Classification B224. 1.2.3 Grade 2 copper may be used to produce OFS designation coppers corresponding to UNS C10400, C10500, and C10700. 1.3 Although this specification includes certain UNS designations as described in Practice E527, these designations are for cross reference only and are not specification requirements. In case of conflict, Specification B170 shall govern. 1.4 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only, except for analytical measurements where SI units are the norm. 1.5 The following hazard caveat pertains only to Section 13 and Annex A1, of this specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
||||||||||||||||||||||
2. Referenced Documents | ||||||||||||||||||||||
|
Poslední aktualizace: 23.12.2024 (Počet položek: 2 217 157)
© Copyright 2024 NORMSERVIS s.r.o.