Cookies
Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
ASTM B115-10(2021)
Standard Specification for Electrolytic Copper Cathode
Přeložit název
NORMA vydána dne 1.7.2021
Informace o normě:
Označení normy: ASTM B115-10(2021)
Poznámka: NEPLATNÁ
Datum vydání normy: 1.7.2021
Kód zboží: NS-1029310
Počet stran: 9
Přibližná hmotnost: 27 g (0.06 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Kategorie - podobné normy:
Anotace textu normy ASTM B115-10(2021) :
Keywords:
cathode, copper, electrolytic copper, electrorefined copper, electrowon copper,, ICS Number Code 77.150.30 (Copper products)
Doplňující informace
| Significance and Use | ||||||||||||||
|
13.1?Calculated values shall be rounded to the desired number of places as directed in Practice E29. |
||||||||||||||
| 1. Scope | ||||||||||||||
|
1.1?This specification establishes the requirements for electrolytic copper cathode; electrorefined and electrowon. 1.2?UnitsThe values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard. Note 1:?Cathode produced to this specification corresponds to
the designation Cath as defined in Classification B224 and may be used to produce all other
coppers listed in Classification B224 that are normally produced from Cath
copper.
Note 2:?Grade 1 cathode conforms to the chemical compositional
requirements of Copper UNS No. C11040, except for oxygen, and is
suitable for the manufacture of wire rod as designated in
Specification B49.
1.3?The following hazard caveat applies to the test methods described in Annex A2 of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.4?This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
||||||||||||||
| 2. Referenced Documents | ||||||||||||||
|
Doporučujeme:
