Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
Standard Specification for Electrolytic Copper Cathode
Automaticky přeložený název:
Standardní specifikace pro elektrolytické mědi katodou
NORMA vydána dne 1.4.2010
Označení normy: ASTM B115-10
Poznámka: NEPLATNÁ
Datum vydání normy: 1.4.2010
Kód zboží: NS-5366
Počet stran: 9
Přibližná hmotnost: 27 g (0.06 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Keywords:
cathode, copper, electrolytic copper, electrorefined copper, electrowon copper, Antimony content--Cu/Cu alloys, Arsenic content, Bismuth content, Cathode copper (electrolytic), Chemicals, Composition analysis, Copper (electrolytic), Iron content--copper, Lead content--metals, Nickel content--Cu/Cu alloys, Sampling nonferrous metals/alloys, Selenium content, Specimen preparation (general), Spectrometry, Sulfur--Cu/Cu alloys, Tellurium content--Cu/Cu alloys, Tin content--Cu/Cu alloys
Significance and Use | ||||||||||||||
Calculated values shall be rounded to the desired number of places as directed in Practice E29. |
||||||||||||||
1. Scope | ||||||||||||||
1.1 This specification establishes the requirements for electrolytic copper cathode; electrorefined and electrowon. 1.2 Units—The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard. Note 1—Cathode produced to this specification corresponds to the designation “Cath” as defined in Classification B224 and may be used to produce all other coppers listed in Classification B224 that are normally produced from “Cath” copper. Note 2—Grade 1 cathode conforms to the chemical compositional requirements of Copper UNS No. C11040, except for oxygen, and is suitable for the manufacture of wire rod as designated in Specification B49. 1.3 The following hazard caveat applies to the test methods described in Annex A2 of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
||||||||||||||
2. Referenced Documents | ||||||||||||||
|
Historická
1.10.2011
Historická
1.10.2013
Historická
1.4.2009
Historická
1.10.2012
Historická
1.4.2012
Historická
1.10.2013
Poslední aktualizace: 22.11.2024 (Počet položek: 2 206 568)
© Copyright 2024 NORMSERVIS s.r.o.