Cookies
Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
ASTM B108/B108M-08
Standard Specification for Aluminum-Alloy Permanent Mold Castings
Automaticky přeložený název:
Standardní specifikace pro hliníkové slitiny Stálá Mold Odlitky
NORMA vydána dne 1.6.2008
Informace o normě:
Označení normy: ASTM B108/B108M-08
Poznámka: NEPLATNÁ
Datum vydání normy: 1.6.2008
Kód zboží: NS-5341
Počet stran: 18
Přibližná hmotnost: 54 g (0.12 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Anotace textu normy ASTM B108/B108M-08 :
Keywords:
aluminum, permanent mold castings, Aluminum alloys (castings)--specifications, Permanent mold castings--aluminum alloy, UNS A02040 (Aluminum foundry alloy, casting), UNS A02080 (Aluminum foundry alloy, casting), UNS A02130 (Aluminum foundry alloy), UNS A02220 (Aluminum foundry alloy, casting), UNS A02420 (Aluminum foundry alloy, casting), UNS A03190 (Aluminum foundry alloy, casting), UNS A03320 (Aluminum foundry alloy, casting), UNS A03330 (Aluminum foundry alloy, casting)
Doplňující informace
| 1. Scope | ||||||||||||||||||||||||||||||||||||||||
|
1.1 This specification covers aluminum-alloy permanent mold castings designated as shown in Table 1. 1.2 This specification is not intended for aluminum-alloy permanent mold castings used in aerospace applications. 1.3 Alloy and temper designations are in accordance with ANSI H35.1/H35.1(M). The equivalent unified numbering system alloy designations are in accordance with Practice E 527. 1.4 Unless the order specifies the “M” specification designation, the material shall be furnished to the inch-pound units. 1.5 For acceptance criteria for inclusion of new aluminum and aluminum alloys and their properties in this specification, see Annex A1 and Annex A2. 1.6 Units—The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard. 1.7 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
||||||||||||||||||||||||||||||||||||||||
| 2. Referenced Documents | ||||||||||||||||||||||||||||||||||||||||
|
Doporučujeme:
