Cookies
Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
SAE J2730
Dynamic Cleat Test with Perpendicular and Inclined Cleats
Přeložit název
NORMA vydána dne 1.5.2025
Informace o normě:
Označení normy: SAE J2730
Datum vydání normy: 1.5.2025
Kód zboží: NS-1220531
Země: Americká technická norma
Kategorie: Technické normy SAE
Anotace textu normy SAE J2730 :
This SAE Recommended Practice describes a test method for measuring the forces and moments generated at a high frequency response spindle when a rolling tire impacts a cleat. The cleat is configured either with its crest perpendicular, 90 degrees, to the path of the tire or optionally with its crest inclined at an angle to the path of the tire. The carriage to which the spindle is attached is rigidly constrained in position during each test condition to provide a good approximation to fixed loaded radius operation. The method discussed in this document provides impact force and moment time histories essentially free from variations due to tire non-uniformities. The method applies to any size tire so long as the equipment is properly scaled to conduct the measurements for the intended test tire. The data are suitable for use in determining parameters for road load models and for comparative evaluations of the measured properties in research and development.
SUBFILE: Aerospace
TYPE OF DOCUMENT: Ground Vehicle Standard
Doporučujeme:
