Cookies
Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
ASTM/ISO 52903-1-20
Additive manufacturing — Material extrusion-based additive manufacturing of plastic materials — Part 1: Feedstock materials
Přeložit název
NORMA vydána dne 1.10.2017
Informace o normě:
Označení normy: ASTM/ISO 52903-1-20
Datum vydání normy: 1.10.2017
Kód zboží: NS-1017402
Počet stran: 4
Přibližná hmotnost: 12 g (0.03 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Anotace textu normy ASTM/ISO 52903-1-20 :
Keywords:
additive manufacturing, AM, feedstock,
Doplňující informace
| 1. Scope |
|
1.1 This document describes a method for defining requirements for plastic materials used in extrusion-based additive manufacturing (AM) processes. Materials include unfilled, filled, and reinforced plastic materials suitable for processing into parts. These materials can also contain special additives (e.g., flame retardants, stabilizers, etc.). Processes include all material extrusion-based AM processes. This document is intended for use by manufacturers of materials, feedstocks, or plastic parts or any combination of the three using material extrusion-based AM. Note 1: In some cases, material manufacturers can also be
feedstock manufacturers. In other cases, a material manufacturer
can supply materials (example: pellets) to a feedstock manufacturer
(example: convertor of pellets into filaments).
This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. |
Doporučujeme:
