Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
Standard Practice for Preparing, Cleaning, and Evaluating Corrosion Test Specimens
NORMA vydána dne 1.12.2011
Označení normy: ASTM G1-03(2011)
Poznámka: NEPLATNÁ
Datum vydání normy: 1.12.2011
Kód zboží: NS-57223
Počet stran: 9
Přibližná hmotnost: 27 g (0.06 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Keywords:
cleaning, corrosion product removal, evaluation, mass loss, metals, preparation, specimens , Chemical cleaning, Cleaning agents/processes, Corrosion, Corrosion--metals/alloys, Corrosion--stress-corrosion, Electrolytic cleaning, Mass loss--corrosion, Solid phase materials, Specimen preparation (for testing)--corrosion testing, Surface analysis--metals/alloys, Visual examination--metals/alloys, ICS Number Code 77.060 (Corrosion of metals)
Significance and Use | ||||||||||||||||||||||
The procedures given are designed to remove corrosion products without significant removal of base metal. This allows an accurate determination of the mass loss of the metal or alloy that occurred during exposure to the corrosive environment. These procedures, in some cases, may apply to metal coatings. However, possible effects from the substrate must be considered. |
||||||||||||||||||||||
1. Scope | ||||||||||||||||||||||
1.1 This practice covers suggested procedures for preparing bare, solid metal specimens for tests, for removing corrosion products after the test has been completed, and for evaluating the corrosion damage that has occurred. Emphasis is placed on procedures related to the evaluation of corrosion by mass loss and pitting measurements. (WarningIn many cases the corrosion product on the reactive metals titanium and zirconium is a hard and tightly bonded oxide that defies removal by chemical or ordinary mechanical means. In many such cases, corrosion rates are established by mass gain rather than mass loss.) 1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific warning statements, see 1.1 and 7.2. |
||||||||||||||||||||||
2. Referenced Documents | ||||||||||||||||||||||
|
Historická
1.3.2011
Historická
1.5.2008
Historická
1.6.2013
Historická
1.5.2013
Historická
1.5.2013
Historická
1.5.2013
Poslední aktualizace: 02.03.2025 (Počet položek: 2 231 032)
© Copyright 2025 NORMSERVIS s.r.o.
Zde máte možnost přizpůsobit si nastavení souborů cookies v souladu s vlastními preferencemi.
Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů.