Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
Standard Practice for Estimating Toner Usage in Copiers Utilizing Dry Two-Component Developer (Withdrawn 2017)
Automaticky přeložený název:
Standardní praxe pro odhad využití toneru do kopírky využití suchých dvousložková Developer
NORMA vydána dne 1.10.2009
Označení normy: ASTM F995-09
Poznámka: NEPLATNÁ
Datum vydání normy: 1.10.2009
Kód zboží: NS-57204
Počet stran: 5
Přibližná hmotnost: 15 g (0.03 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Keywords:
copiers, test target, toner usage, two-component toner, Developers, Electrostatic copier, Point count, Toner usage, Two-component developer materials, ICS Number Code 37.100.10 (Reproduction equipment)
Significance and Use | ||||||
This practice may be used to evaluate the performance of different toners in a common machine. It can also be used to evaluate the economics of toner usage when making machine-to-machine comparisons. The practice provides only a point estimate that is subject to a significant number of variables that are not easily measured. As with all dry developers, two-component developer systems are not 100 % efficient. Some toner is lost to the surroundings (inside or outside the copier). This loss is also dependent on copier adjustments and may be significant enough to affect the total number of copies capable of being produced by a specific amount of toner. Anyone making a decision based on the results of this practice should carefully consider the accuracy of the results and other pertinent data. Actual use of the copier in normal operating conditions will most likely result in toner usage values different from those generated in this practice. |
||||||
1. Scope | ||||||
1.1 This practice describes a procedure for estimating the number of copies that can be produced for a given unit of toner in a copier using dry two-component developer. 1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of whoever uses this standard to consult and establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. See Section 9 for specific precautionary statements. |
||||||
2. Referenced Documents | ||||||
|
Historická
1.2.2009
Historická
1.10.2011
Historická
1.4.2013
Historická
1.4.2013
Historická
1.10.2011
Historická
1.4.2013
Poslední aktualizace: 29.11.2024 (Počet položek: 2 209 895)
© Copyright 2024 NORMSERVIS s.r.o.