Cookies
Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
ASTM F879M-02a(2008)
Standard Specification for Stainless Steel Socket Button and Flat Countersunk Head Cap Screws (Metric) (Includes all amendments And changes 10/30/2015).
Automaticky přeložený název:
Standardní specifikace pro Stainless Steel Socket Button a plochou zápustnou hlavou šrouby (metrické)
NORMA vydána dne 1.5.2008
Informace o normě:
Označení normy: ASTM F879M-02a(2008)
Poznámka: NEPLATNÁ
Datum vydání normy: 1.5.2008
Kód zboží: NS-56781
Počet stran: 6
Přibližná hmotnost: 18 g (0.04 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Anotace textu normy ASTM F879M-02a(2008) :
Keywords:
corrosion resistant, stainless steel, socket button head cap screws, socket flat countersunk head cap screws, Countersunk head cap screws--specifications, Head cap screws, Screws--specifications, Stainless steel screws--specifications, Steel screws--specifications, ICS Number Code 21.060.10 (Bolts, screws, studs)
Doplňující informace
| 1. Scope | ||||||||||||||||||||||||||||||||
|
1.1 This specification covers the chemical and mechanical requirements for stainless steel metric hexagon socket button (SBHCS) and flat countersunk (SFHCS) head cap screws with nominal thread M 3 through M 20 intended for use in applications requiring general corrosion resistance. 1.2 The following three property classes are covered: 1.2.1 Austenitic Class A 1-50 in an annealed condition at 585 MPa maximum, 1.2.2 Austenitic Class A1–55 in a cold worked condition at 550 MPa minimum, and 1.2.3 Austenitic Class A 1-70 in a cold-worked condition at 700 MPa minimum. 1.3 Units—The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.4 The following hazard caveat pertains only to Section 12, Test Methods: This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
||||||||||||||||||||||||||||||||
| 2. Referenced Documents | ||||||||||||||||||||||||||||||||
|
Doporučujeme:
