Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
Standard Test Method for Determining Change in Groove (or Void) Depth With Distance Traveled for Passenger Car Tires
Automaticky přeložený název:
Standardní zkušební metoda pro stanovení Změna v Groove ( nebo Void ) Hloubka ujetou vzdálenost za osobního automobilu pneumatiky
NORMA vydána dne 1.10.2008
Označení normy: ASTM F762/F762M-08
Poznámka: NEPLATNÁ
Datum vydání normy: 1.10.2008
Kód zboží: NS-56372
Počet stran: 4
Přibližná hmotnost: 12 g (0.03 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Keywords:
test course, tire, tire groove depth loss, tire test, trip sheet, Footprints (in tires), Groove area analysis/measurement, Passenger car tires, Tire groove depth loss, Tire testing, Tread surface wear patterns, Trip sheet, Voids--passenger car tires, ICS Number Code 83.160.10 (Road vehicle tyres)
Significance and Use | ||||||||||
The test data obtained with this test method may be used to compare the performance of various tires for the conditions under which they were tested. This test method is suitable for a variety of quality assurance, research, and development purposes, when tires are to be compared during a single series of tests. The procedure described may not be suitable for regulatory statutes or specification acceptance because the values obtained may not agree, or correlate either in rank order or absolute tread wear performance level, with values obtained on other road surfaces, or on the same surface after additional wear, under other environmental conditions, on other test vehicles, or with results obtained by other test procedures. |
||||||||||
1. Scope | ||||||||||
1.1 This test method covers a procedure to be used to obtain data for determining the changes in tire tread depth over any specified course and test period. 1.2 The tire tread depth loss data obtained according to the procedures for this test method may be used to calculate tire tread wear by way of the procedures described in Practice F 1016. 1.3 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
||||||||||
2. Referenced Documents | ||||||||||
|
Poskytování aktuálních informací o legislativních předpisech vyhlášených ve Sbírce zákonů od roku 1945.
Aktualizace 2x v měsíci !
Chcete vědět více informací? Podívejte se na tuto stránku.
Poslední aktualizace: 06.09.2024 (Počet položek: 2 346 102)
© Copyright 2024 NORMSERVIS s.r.o.