Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
Standard Practice for Drafting Impact Test Requirements In Thermoplastic Pipe And Fittings Standards
Automaticky přeložený název:
Standardní praktiky pro kreslení nárazové zkoušky Požadavky termoplastické trubky a tvarovky standardy
NORMA vydána dne 1.1.1996
Označení normy: ASTM F725-89(1996)
Poznámka: NEPLATNÁ
Datum vydání normy: 1.1.1996
Kód zboží: NS-56265
Počet stran: 4
Přibližná hmotnost: 12 g (0.03 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Keywords:
Impact testing-plastics, Pipe fittings-plastic (general), Plastic pipe/tubing/fittings-thermoplastic, drafting impact test requirements in thermoplastic pipe/fitting, standards, practice,, Resistance-impact (plastics), thermoplastic pipe/fittings-drafting impact test requirements in, standards, practice, ICS Number Code 23.040.20 (Plastic pipes), 23.040.45 (Plastic fittings)
1. Scope | ||
1.1 This practice describes a procedure for setting up impact test requirements on the basis of test data obtained by Test Method D2444. 1.2 This practice is applicable to thermoplastic pipe and fittings. 1.3 This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
||
2. Referenced Documents | ||
|
Poslední aktualizace: 08.07.2025 (Počet položek: 2 207 474)
© Copyright 2025 NORMSERVIS s.r.o.