ASTM F714-21a

1.1?This specification covers polyethylene (PE) pipe made in three standard outside diameter sizing systems, based on outside diameters of DIPS 3, IPS 4, Metric 90 mm and larger. For smaller sizes refer to Specification D3035. See 5.2.5 for guidelines on special sizes.

1.2?The piping is intended for new construction and insertion renewal of old piping systems used for the transport of water, municipal sewage, domestic sewage, industrial process liquids, effluents, slurries, etc., in both pressure and nonpressure systems.

1.3?All pipes produced under this specification are pressure-rated. See Appendix X5 for information on pressure rating.

1.4?This specification includes criteria for choice of raw material, together with performance requirements and test methods for determining conformance with the requirements.

1.5?Quality-control measures are to be taken by manufacturers. See Appendix X4 for general information on quality control.

1.6?UnitsThe values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.7?The following safety hazards caveat pertains only to the test methods portion, Section 6, of this specification: 1.8?This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.