Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
Standard Specification for Stainless Steel Bolts, Hex Cap Screws, and Studs (Includes all amendments And changes 8/30/2016).
Automaticky přeložený název:
Standardní specifikace pro nerezovými šrouby, Hex Cap šrouby, a šrouby
NORMA vydána dne 1.12.2013
Označení normy: ASTM F593-13a
Poznámka: NEPLATNÁ
Datum vydání normy: 1.12.2013
Kód zboží: NS-55813
Počet stran: 9
Přibližná hmotnost: 27 g (0.06 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Keywords:
bolts, general use, hex cap screws, stainless, studs, ICS Number Code 21.060.10 (Bolts, screws, studs)
Significance and Use | ||||||||||||||||||||||||||||||||||||
13.1 For the purposes of determining compliance with the specified limits for properties listed in this specification, an observed value or calculated value shall be rounded in accordance with Practice E29. |
||||||||||||||||||||||||||||||||||||
1. Scope | ||||||||||||||||||||||||||||||||||||
1.1 This specification covers the requirements for stainless steel bolts, hex cap screws, and studs 0.25 to 1.50 in., inclusive, in nominal diameter in a number of alloys in common use and intended for service applications requiring general corrosion resistance. 1.2 Seven groups of stainless steel
alloys are covered, including thirteen austenitic, two ferritic,
four martensitic, and one precipitation hardening.
1.3 Supplementary requirements of an
optional nature are provided, applicable only when agreed upon
between the manufacturer and the purchaser at the time of the
inquiry and order.
1.4 Suitable nuts for use with bolts, hex cap screws, and studs included in this specification are covered by Specification F594. Unless otherwise specified, all nuts used on these fasteners shall conform to the requirements of Specification F594, shall be of the same alloy group, and shall have a specified minimum proof stress equal to or greater than the specified minimum full-size tensile strength of the externally threaded fastener. 1.5 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard. 1.6 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
||||||||||||||||||||||||||||||||||||
2. Referenced Documents | ||||||||||||||||||||||||||||||||||||
|
Historická
1.4.2012
Historická
1.4.2013
Historická
1.10.2013
Historická
1.8.2011
Historická
1.3.2013
Historická
1.12.2011
Poslední aktualizace: 22.11.2024 (Počet položek: 2 206 568)
© Copyright 2024 NORMSERVIS s.r.o.