Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
Standard Specification for Eye and Face Protective Equipment for Hockey Players
Přeložit název
NORMA vydána dne 15.6.2022
Označení normy: ASTM F513-22
Datum vydání normy: 15.6.2022
Kód zboží: NS-1067864
Počet stran: 15
Přibližná hmotnost: 45 g (0.10 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Keywords:
eye protective equipment, face protective equipment, ice hockey,, ICS Number Code 13.340.20 (Head protective equipment),97.220.30 (Indoor sports equipment)
1. Scope | ||||||
1.1?This specification covers performance requirements and test methods for face protectors marketed, sold, and intended for ice hockey. 1.2?The intent of this specification is to reduce the risk of injury to the face without compromising the form or appeal of the game. To do so, the face protector shall be used: 1.2.1?As intended within the rules of the game and 1.2.2?In accordance with the manufacturers instructions. 1.3?Ice hockey is a sport with intrinsic hazards associated with the normal conduct of the game. Participation in ice hockey implies the acceptance of some risk of injury. Use of a face protector certified to this specification will not prevent all injuries. 1.4?This specification has been prepared after careful consideration of the frequency and mechanisms associated with facial and eye injuries that can potentially occur within the rules of the game of ice hockey. 1.5?Requirements and the corresponding test methods, where appropriate, are given for the following: 1.5.1?Construction, 1.5.2?Puck impact resistance, 1.5.3?Penetration, 1.5.4?Field of vision, and 1.5.5?Marking and information. 1.6?Face protection is intended for use by players, goalkeepers, and certain functionaries (for example, referees and coaches). Types of protectors considered under this specification are: 1.6.1?Type B1A full-face protector intended for use by persons older than ten years of age, other than goaltenders; 1.6.2?Type B2A full-face protector intended for use by persons ten years of age or younger, other than goaltenders; and 1.6.3?Type C (Visor)A visor intended for use by person in the junior age category and older, other than goaltenders. 1.7?UnitsThe values stated in SI units are to be regarded as the standard. No other units of measurement are included in this standard. 1.8?Use of the singular does not exclude the plural (and vice versa) when the sense allows. 1.9?Although the intended primary application of this specification is stated in this scope, note that it remains the responsibility of the users of this specification to judge its suitability for their particular purpose. 1.10?This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.11?This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
||||||
2. Referenced Documents | ||||||
|
Chcete mít jistotu, že používáte pouze platné technické normy?
Nabízíme Vám řešení, které Vám zajistí měsíční přehled o aktuálnosti norem, které používáte.
Chcete vědět více informací? Podívejte se na tuto stránku.
Poslední aktualizace: 04.11.2024 (Počet položek: 2 209 323)
© Copyright 2024 NORMSERVIS s.r.o.