Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
Standard Test Method for Speed and Distance Calibration of Fifth Wheel Equipped With Either Analog or Digital Instrumentation
Přeložit název
NORMA vydána dne 1.5.2017
Označení normy: ASTM F457-04(2017)
Poznámka: NEPLATNÁ
Datum vydání normy: 1.5.2017
Kód zboží: NS-688331
Počet stran: 4
Přibližná hmotnost: 12 g (0.03 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Keywords:
analog, calibration, digital, distance, fifth wheel, speed,, ICS Number Code 43.020 (Road vehicles in general)
Significance and Use | ||||
5.1 This test method may be used for calibration of speed and distance measurement systems used on tire test vehicles and tire test trailers, or any land-based vehicle that contacts the road and that uses a trailing-wheel system for measurement of speed and distance. This test method applies only to hard, dry, smooth surfaces and is not accurate for highly curved vehicle paths. This test method does not encompass optical types of devices. |
||||
1. Scope | ||||
1.1 This test method covers the determination of vehicle speed and cumulative distance traveled using a device termed a fifth wheel and using appropriate associated instrumentation. 1.2 This test method also describes the calibration technique applicable to digital or analog speed and distance measurement systems employing a fifth wheel. 1.3 The values stated in SI (millimetre-kilogram) units are to be regarded as the standard. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For specific precautionary statements, see Section 7. 1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
||||
2. Referenced Documents | ||||
|
Chcete mít jistotu o platnosti užívaných předpisů?
Nabízíme Vám řešení, abyste mohli používat stále platné (aktuální) legislativní předpisy.
Chcete vědět více informací? Podívejte se na tuto stránku.
Poslední aktualizace: 21.11.2024 (Počet položek: 2 206 478)
© Copyright 2024 NORMSERVIS s.r.o.