Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
Standard Consumer Safety Specification for Non-Full-Size Baby Cribs/Play Yards (Includes all amendments And changes 8/16/2017).
Automaticky přeložený název:
Standard Specification spotřebitelů Bezpečnost pro Non - Full-Size dětské postýlky pro / Play Yards
NORMA vydána dne 1.9.2005
Označení normy: ASTM F406-05a
Poznámka: NEPLATNÁ
Datum vydání normy: 1.9.2005
Kód zboží: NS-55178
Počet stran: 21
Přibližná hmotnost: 63 g (0.14 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Keywords:
non-full-size crib, playpen, play yard, ICS Number Code 97.220.30 (Indoor sports equipment), 97.220.40 (Outdoor and water sports equipment)
1. Scope | ||||||||||||||||||||||
1.1 This consumer safety specification establishes testing requirements for structural integrity and performance requirements for non-full-size cribs/play yards, both rigid sided and mesh/fabric assemblies. It also provides requirements for labeling and instructional material. The term unit or product will refer to a non-full-size crib/play yard. 1.2 This specification covers a framed enclosure with a floor made for the purpose of providing sleeping and playing accommodations for a child who cannot climb out and is less than 35 in. (890 mm) in height. It also covers bassinet, changing table, or similar attachments to a non-full size crib/play yard. These attachments shall also comply with the applicable requirements of ASTM standards addressing those attachments. For example, a changing table that attaches to a play yard shall also comply with the applicable requirements in Specification F 2388. 1.3 No product produced after the approval date of this consumer safety specification shall, either by label or other means, indicate compliance with this specification unless it conforms to all applicable requirements contained herein, before and after all testing. 1.4 The values stated in inch-pound units are to be regarded as the standard. The SI units given in parentheses are for information only. The following safety hazards caveat pertains only to the test method portion, Section 8, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
||||||||||||||||||||||
2. Referenced Documents | ||||||||||||||||||||||
|
Poslední aktualizace: 23.12.2024 (Počet položek: 2 217 157)
© Copyright 2024 NORMSERVIS s.r.o.