Cookies
Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
ASTM F366-17
Standard Specification for Fixation Pins and Wires
Přeložit název
NORMA vydána dne 1.9.2017
Informace o normě:
Označení normy: ASTM F366-17
Poznámka: NEPLATNÁ
Datum vydání normy: 1.9.2017
Kód zboží: NS-798512
Počet stran: 4
Přibližná hmotnost: 12 g (0.03 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Kategorie - podobné normy:
Anotace textu normy ASTM F366-17 :
Keywords:
fixation materials, flexible surgical wire, orthopaedic medical devices, wire-surgical implants,, ICS Number Code 21.060.60 (Rings, bushes, sleeves, collars)
Doplňující informace
| 1. Scope | ||||||||||||||||||||||||
|
1.1 This specification covers functional dimensions for fixation pins and wires. 1.2 In recognition of many broad and varied uses of such pins and wires, many options are included. A variety, but not necessarily all, of the options are illustrated in Figs. 1-3. FIG. 1 Fixation Pins and Wires Note 1: Pins and wires may be smooth shank or
threaded.
Note 2: Point angle and helix angle, where applicable, is as
specified by the manufacturer.
Note 3: On square or triangular shanks, flats are equal and
corners are on the same circumference as the pin diameter. Shank
diameters on pins larger than 3.2 mm may be reduced.
Note 4: Optional designs, both ends pointed or point with
suture hole.
FIG. 2 Fixation Pin-Knowles Type Note 1: Shall be made of one piece of material; that is, not
an assembly of two or more pieces.
Note 2: Thread major diameter may be the same or larger than
the shaft diameter.
Note 3: Thread length shall be optional to suit the intended
medical application.
Note 4: Optional marking in this location.
FIG. 3 Fixation Pin-Hagie Type Note 1: Thread major diameter may be the same or larger than
the shaft diameter.
Note 2: Thread length shall be optional to suit the intended
medical application.
1.3 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard. 1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
||||||||||||||||||||||||
| 2. Referenced Documents | ||||||||||||||||||||||||
|
Doporučujeme:
