Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
Standard Practice for Determining the Maintenance Factor (m) and Yield Factor (y) Loading Constants Applicable to Gasket Materials and Designs
Automaticky přeložený název:
Standardní praktiky pro Určení Údržba faktoru (M) a faktor výnosu (Y) Vkládání konstanty vztahujících se na těsnicích materiálů a vzory
NORMA vydána dne 1.6.2015
Označení normy: ASTM F3149-15
Poznámka: NEPLATNÁ
Datum vydání normy: 1.6.2015
Kód zboží: NS-613256
Počet stran: 7
Přibližná hmotnost: 21 g (0.05 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Keywords:
gasket designs, gasket materials, loading constants, m, maintenance factor, y, yield factor,, ICS Number Code 21.140 (Seals, glands)
Significance and Use | ||||||||||||
4.1 The gasket factors are a function of leak rate; therefore, this practice generates curves. Constants for use in the ASME Boiler and Pressure Vessel Code, Section VIII, Appendix 2 code calculations are selected from these data. Specific 4.2 This practice determines two general characteristics that are specific to the ASME design criteria. Caution should be exercised when comparing yield and maintenance factors between gasket materials, and it is recommended that the 4.3 This practice builds upon work conducted in the Fluid Sealing Association (FSA G 605:11). The associated round robin data is provided for reference in Tables 1-4. 1.1 This practice will establish criteria
for determining loading constants that are referenced in the
American Society of Mechanical Engineers (ASME) pressure vessel
design (Boiler and Pressure Vessel Code, Section VIII, Divs. 1 and
2). These constants are specific to this design criterion for
metallic, semi-metallic, and nonmetallic gaskets.
1.2 Units—The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
||||||||||||
2. Referenced Documents | ||||||||||||
|
Chcete mít jistotu o platnosti užívaných předpisů?
Nabízíme Vám řešení, abyste mohli používat stále platné (aktuální) legislativní předpisy.
Chcete vědět více informací? Podívejte se na tuto stránku.
Poslední aktualizace: 28.04.2024 (Počet položek: 2 896 137)
© Copyright 2024 NORMSERVIS s.r.o.