Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
Standard Practice for Classification, Design, Manufacture, Construction, Maintenance, and Operation of Stationary Wave Systems
Přeložit název
NORMA vydána dne 1.5.2021
Označení normy: ASTM F3133-21
Poznámka: NEPLATNÁ
Datum vydání normy: 1.5.2021
Kód zboží: NS-1026860
Počet stran: 5
Přibližná hmotnost: 15 g (0.03 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Keywords:
boogie board, construction, design, manufacture, ride surface, ride vehicle, runout area, stationary wave, surf,, ICS Number Code 97.220.99 (Other sports equipment and facilities)
1. Scope | ||||||||||||
1.1?This practice applies to the classification, design, manufacture, construction, operation, maintenance, and inspection of stationary waves. 1.2?Stationary wave systems shall be defined as a system that delivers a constantly flowing sheet of water nominally up to 24 in. thick travelling over a form allowing for patron interaction with a perpetual wave. 1.3?Significance and Use:? 1.3.1?For the purposes of this practice, a wave system could include: 1.3.1.1?The ride surface, 1.3.1.2?The ride feature pump(s), 1.3.1.3?The water filtration and disinfection system, 1.3.1.4?The runout areas, 1.3.1.5?The structural supports, 1.3.1.6?Vehicles or other aquatic accessories that are part of the water ride as defined by the designer/engineer, and 1.3.1.7?Control systems. 1.3.2?This practice shall not apply to: 1.3.2.1?Amusement rides and devices whose design criterion is specifically addressed in other ASTM standards; 1.3.2.2?Preexisting designs manufactured before the effective date of publication of this practice if the design is service proven as defined in Practice F2291; and 1.3.2.3?Deep water wave pools, Action Rivers, lazy rivers or waterslides. 1.3.3?The terms stationary wave systems, standing wave systems, sheet wave systems, and wave systems shall be considered equivalent when used in this practice. 1.4?The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard. 1.5?This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.6?This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
||||||||||||
2. Referenced Documents | ||||||||||||
|
Chcete mít jistotu, že používáte pouze platné technické normy?
Nabízíme Vám řešení, které Vám zajistí měsíční přehled o aktuálnosti norem, které používáte.
Chcete vědět více informací? Podívejte se na tuto stránku.
Poslední aktualizace: 30.08.2024 (Počet položek: 2 345 304)
© Copyright 2024 NORMSERVIS s.r.o.