Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
Standard Specification for Welded Wire Mesh Fence Fabric (Metallic-Coated or Polymer Coated) with Variable Mesh Patterns or Meshes Greater than 6 in.2 [3871 mm2] in Panels
Automaticky přeložený název:
Standardní specifikace pro svařované drátěné pletivo plot Fabric (Metallic potahem nebo Polymer Coated) s variabilním Mesh vzory nebo pletiva větší než 6 odstavci.2 [3871 mm2] v panelech
NORMA vydána dne 1.3.2012
Označení normy: ASTM F2919/F2919M-12
Poznámka: NEPLATNÁ
Datum vydání normy: 1.3.2012
Kód zboží: NS-54731
Počet stran: 7
Přibližná hmotnost: 21 g (0.05 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Keywords:
galvanized before welding, galvanized after welding, organic polymer coatings., steel, welded mesh sizes, welded wire mesh fence fabric , zinc-5&thinsp,% aluminum-mishmetal alloy coated before welding, zinc and polymer coated, Fences/fencing materials (mesh), Panels, Wire, ICS Number Code 77.140.65 (Steel wire, wir ropes and link chains)
1. Scope | ||||||||||||||||||||||||||
1.1 This specification covers welded wire mesh fence fabric produced from steel wire or metallic-coated steel wire. The metallic-coated fabric may be polymer coated after fabrication. 1.2 Welded wire mesh fence fabric is produced in four types, based on the kind of coating, as described in Section 4. 1.3 This specification is applicable to orders in either inch-pound units or SI units. Values stated in either inch-pound or SI units are to be regarded separately as the standard. Within the text, the SI units are shown in brackets. The values in the two systems are not exact equivalents; therefore, each system shall be used independent of the other, without combining values in any way. 1.4 This specification references notes and footnotes, which provide explanatory material. These notes and footnotes (excluding those in tables and figures) shall not be considered as requirements of this specification. 1.5 The following safety hazards caveat pertains only to the test methods portion, 13.4, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
||||||||||||||||||||||||||
2. Referenced Documents | ||||||||||||||||||||||||||
|
Historická
1.10.2013
Historická
1.6.2011
Historická
1.10.2013
Historická
1.10.2013
Historická
1.4.2013
Historická
1.3.2014
Poslední aktualizace: 22.11.2024 (Počet položek: 2 206 568)
© Copyright 2024 NORMSERVIS s.r.o.