Cookies
Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
ASTM F2750-16
Standard Test Method for Determining the Effects of Bending a Membrane Switch or Printed Electronic Device (Withdrawn 2023)
Přeložit název
NORMA vydána dne 1.5.2016
Informace o normě:
Označení normy: ASTM F2750-16
Poznámka: NEPLATNÁ
Datum vydání normy: 1.5.2016
Kód zboží: NS-638491
Počet stran: 3
Přibližná hmotnost: 9 g (0.02 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Kategorie - podobné normy:
Anotace textu normy ASTM F2750-16 :
Keywords:
bend, mandrel, membrane switch, printed electronic device, tail assembly,, ICS Number Code 29.120.40 (Switches)
Doplňující informace
| Significance and Use |
|
3.1 Bending of membrane switches, printed electronic device or their components can affect their visual appearance, mechanical integrity or electrical functionality. This test method simulates conditions that may be seen during manufacture, installation or use. 3.2 Bend testing may be destructive, therefore any samples tested should be considered unfit for future use. 3.3 Specific areas of testing include, but are not limited to: 3.3.1 Membrane switch flex tails or printed electronic device, and 3.3.2 Any component of a membrane switch or printed electronic device that may be subjected to bending. |
| 1. Scope |
|
1.1 This test method establishes a method for the bending of any part of a membrane switch or printed electronic device with conductive circuits. 1.1.1 The values given in SI units are to be regarded as the standard. The values given in parentheses are for information only. 1.2 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
Doporučujeme:
