Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
Standard Practice for Inspection of Aircraft Electrical Wiring Systems
Přeložit název
NORMA vydána dne 1.6.2019
Označení normy: ASTM F2696-14(2019)
Datum vydání normy: 1.6.2019
Kód zboží: NS-951100
Počet stran: 7
Přibližná hmotnost: 21 g (0.05 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Elektrická zařízení a elektrické palubní systémy letadel a kosmických dopravních prostředků
Keywords:
aircraft electrical wiring system, electrical system, electrical wiring system, inspection, wire,, ICS Number Code 49.060 (Aerospace electric equipment and systems)
Significance and Use | ||
4.1 The term “electrical system” as used in this practice means those parts of the aircraft that generate, distribute, and use electrical energy, including their support and attachments. 4.2 The satisfactory performance of an aircraft is dependent upon the continued reliability of the electrical system. 4.3 Damaged wiring or equipment in an aircraft, regardless of how minor it may appear to be, cannot be tolerated. It is, therefore, important that maintenance be accomplished using the best techniques and practices to minimize the possibility of failure. 4.4 When inspecting and evaluating EWIS, improper wiring, routing, or repairs shall be corrected regardless of the origin of the error. 4.5 This practice is not intended to supersede or replace any government specification or specific manufacturer’s instruction regarding electrical system inspection and repair |
||
1. Scope | ||
1.1 This practice covers basic inspection procedures for electrical wiring interconnect systems for aircraft electrical wiring systems. 1.2 This practice is not intended to replace any instructions for continued airworthiness published by the aircraft or accessory manufacturer or type design holder. 1.3 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard. 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. 1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
||
2. Referenced Documents | ||
|
Chcete mít jistotu, že používáte pouze platné technické normy?
Nabízíme Vám řešení, které Vám zajistí měsíční přehled o aktuálnosti norem, které používáte.
Chcete vědět více informací? Podívejte se na tuto stránku.
Poslední aktualizace: 03.05.2024 (Počet položek: 2 896 946)
© Copyright 2024 NORMSERVIS s.r.o.