Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
Standard Specification for Resilient Connectors Between Reinforced Concrete Manhole Structures and Corrugated High Density Polyethylene Drainage Pipes
Automaticky přeložený název:
Standard Specification na elastické konektory mezi železobeton průlez konstrukcí a vlnité High Density Roury polyetylénové drenážní
NORMA vydána dne 1.2.2013
Označení normy: ASTM F2510/F2510M-07(2013)
Poznámka: NEPLATNÁ
Datum vydání normy: 1.2.2013
Kód zboží: NS-54033
Počet stran: 3
Přibližná hmotnost: 9 g (0.02 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Keywords:
corrugated HDPE pipe, design test method, hydrostatic testing, leakage tests, manholes, resilient connectors, seals, ICS Number Code 93.030 (External sewerage systems)
1. Scope | ||||||||||||||||||||||||
1.1 This specification covers the design, material, and minimum performance requirements of resilient connectors used for connections between reinforced concrete structures conforming to Specifications C478 and C913 to annular corrugated profile wall high density polyethylene (HDPE) drainage pipe conforming to AASHTO M252 or Specification F2306/F2306M. 1.1.1 These connectors are designed to provide a positive seal between the pipe and manholes or other structures subjected to internal and external hydrostatic pressures less than 10.8 psi [74 KPa]. 1.1.2 Testing under this standard is limited to hydrostatic pressures. Alternate air and vacuum pressure testing involve unique testing protocols and are not addressed under this standard. 1.1.3 Testing under this standard is conducted in a laboratory as a proof of design certification. Actual field performance testing would be accomplished and accepted under individual project performance standards or pipeline acceptance criteria, which is outside the scope of this standard. 1.2 The values stated in either
inch-pound units or SI units are to be regarded separately as
standard. Within the text the SI units are shown in brackets. The
values stated in each system may not be exact equivalents:
therefore, each system shall be used independently of the other.
Combining values from the two systems may result in non-conformance
with the standard.
1.3 The following precautionary caveat pertains only to the test methods portion, Section 7. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. For a specific precaution statement, see 7.2.3. |
||||||||||||||||||||||||
2. Referenced Documents | ||||||||||||||||||||||||
|
Historická
1.7.2013
Historická
1.9.2011
Historická
1.7.2013
Historická
1.7.2013
Historická
1.5.2008
Historická
1.8.2011
Chcete pravidelně odebírat informace o nově vycházejících normách z celého světa a to zcela zdarma?
Přihlašte se k odběru. Vše je velice jednoduché a absolutně ZDARMA.
Na výběr máte vydavatele z celého světa.
Poslední aktualizace: 02.09.2024 (Počet položek: 2 345 509)
© Copyright 2024 NORMSERVIS s.r.o.