Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
Standard Specification for Bearing, Roller, Needle: Assembly (Thick Outer Race)
Přeložit název
NORMA vydána dne 15.8.2018
Označení normy: ASTM F2430-04(2018)
Datum vydání normy: 15.8.2018
Kód zboží: NS-905726
Počet stran: 4
Přibližná hmotnost: 12 g (0.03 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
This specification covers needle roller bearing assemblies that have thick outer rings, cages, rollers and inner rings. The assemblies consist of a MS51961 thick outer race needle roller bearing as specified and a corresponding MS51962 inner ring as specified. The bearings are intended to be used on unhardened shafts. MS51961 bearings without inner rings may be used directly on hardened shafts. Bearings designed to this specification are intended for use in applications requiring high radial load with minimal angular shaft misalignment. Requirements such as heat treatment of bearing and inner rings, protective coating and lubrication are also discussed.
Keywords:
cage, inner ring, MS500072, MS51961, MS51962, needle roller, outer ring, radial bearing,, ICS Number Code 21.100.20 (Rolling bearings)
1. Scope | ||||||||||||
1.1 This specification covers needle roller bearing assemblies. These assemblies have thick outer rings, cages, rollers, and inner rings. The assemblies consist of a MS51961 thick outer race needle roller bearing as specified in Specification F2246 and a corresponding MS51962 inner ring as specified in Specification F2431 1.2 The bearings being specified are intended to be used on unhardened shafts. MS51961 bearings without inner rings, as specified in Specification F2246, may be used for used directly on hardened shafts (HRC58–65; see Test Methods E18). 1.3 Bearings designed to this specification are intended for use in applications requiring high radial load with minimal angular shaft misalignment. 1.4 This specification contains many of the requirements of MS500072, which was originally developed by the Department of Defense and maintained by the Defense Supply Center in Richmond. The following government activity codes may be found in the Department of Defense, Standardization Directory SD-1.
1.5 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard. 1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
||||||||||||
2. Referenced Documents | ||||||||||||
|
Poslední aktualizace: 22.12.2024 (Počet položek: 2 217 000)
© Copyright 2024 NORMSERVIS s.r.o.