Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
Standard Test Method for Collection and Analysis of Visible Emissions from Candles as They Burn
Automaticky přeložený název:
Standardní zkušební metoda pro sběr a analýzu viditelných emisí ze svíček as spálí
NORMA vydána dne 1.1.2015
Označení normy: ASTM F2326-04(2015)
Poznámka: NEPLATNÁ
Datum vydání normy: 1.1.2015
Kód zboží: NS-581159
Počet stran: 5
Přibližná hmotnost: 15 g (0.03 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Keywords:
candles, densitometer, visible emissions,, ICS Number Code 13.040.40 (Stationary source emissions)
Significance and Use | ||||
5.1 The intent of this test method is to aid the candle manufacturer to optimize candle formulations in the reduction of visible smoke emissions. 5.2 This test method is intended to provide candle manufacturers a standard procedure to use during development of candle designs and formulations to compare relative smoke/burn behavior. For the development of this method, a protocol was established for trimming the wick on specially prepared test candles to 6 to 7 mm (1/4 in.) prior to each burn cycle. It is recommended that the manufacturer determine a standardized protocol, that is, either not trimming the wick or trimming the wick to an appropriate length in order for direct comparison of results. 5.3 A relative ranking of candle formulations can be established with the use of a histogram of the data and control charts. 5.4 This test method is not intended to set forth pass/fail criteria for visible smoke emissions from candles, as such, this method sets no standard level for visible smoke emissions. |
||||
1. Scope | ||||
1.1 This test method covers the collection and analysis of visible emissions from indoor use candles as they burn. 1.2 The test is to be used to compare relative smoke/burn behavior during development of candle designs and formulations. 1.3 This test method may not be suitable for multiple wick candles; tapers and candles intended to be burned while floating on water commonly known as “floaters.” 1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
||||
2. Referenced Documents | ||||
|
Historická
1.3.2011
Historická
1.4.2012
Historická
1.4.2013
Historická
15.4.2014
Historická
15.7.2012
Historická
1.11.2011
Chcete mít jistotu o platnosti užívaných předpisů?
Nabízíme Vám řešení, abyste mohli používat stále platné (aktuální) legislativní předpisy.
Chcete vědět více informací? Podívejte se na tuto stránku.
Poslední aktualizace: 07.05.2024 (Počet položek: 2 897 585)
© Copyright 2024 NORMSERVIS s.r.o.