Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
Standard Test Method for Prerinse Spray Valves
Přeložit název
NORMA vydána dne 1.5.2019
Označení normy: ASTM F2324-13(2019)
Datum vydání normy: 1.5.2019
Kód zboží: NS-952857
Počet stran: 11
Přibližná hmotnost: 33 g (0.07 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Keywords:
gallons per minute, force, force gauge, force test, prerinse spray valve, pre-rinse spray valve, prerinse, pre-rinse, spray force, spray valve, test method,, ICS Number Code 23.060.99 (Other valves)
Significance and Use | ||||
5.1 The flow rate test is used to confirm that the prerinse spray valve is operating at the manufacturer's rated flow rate at the specified water pressure. The result from this test would also assist the operator in controlling the water and sewer consumption and reduce water heating bills. 5.2 The spray force is a measure of the impact from a prerinse spray valve on the target surface and can be used to select a model that meets an end-user’s force profile. 5.3 Flow rate and spray force can be used along with spray pattern, coverage area, usage time, and flow control to select a prerinse spray valve that meets an end-user’s performance requirements. |
||||
1. Scope | ||||
1.1 This test method covers the water consumption flow rate and spray force of prerinse spray valves. The food service operator can use this evaluation to select a prerinse spray valve and understand its water consumption and spray force. 1.2 The following procedures are included in this test method: 1.2.1 Water consumption (see 10.2). 1.2.2 Spray force test (see 10.3). 1.3 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard. 1.4 This test method may involve hazardous materials, operations, and equipment. It does not address all of the potential safety problems associated with its use. It is the responsibility of the users of this test method to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to its use. 1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
||||
2. Referenced Documents | ||||
|
Poslední aktualizace: 05.09.2024 (Počet položek: 2 346 132)
© Copyright 2024 NORMSERVIS s.r.o.