Cookies
Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
ASTM F2306/F2306M-13
Standard Specification for 12 to 60 in. [300 to 1500 mm] Annular Corrugated Profile-Wall Polyethylene (PE) Pipe and Fittings for Gravity-Flow Storm Sewer and Subsurface Drainage Applications
Automaticky přeložený název:
Standardní specifikace pro 12-60 palec [ 300 do 1500mm ] Prstencové Vlnitý Profile -Wall Polyethylen ( PE ) trubky a armatury pro Gravity - Flow dešťové kanalizace a podpovrchové Odvodňovací aplikací
NORMA vydána dne 1.1.2013
Informace o normě:
Označení normy: ASTM F2306/F2306M-13
Poznámka: NEPLATNÁ
Datum vydání normy: 1.1.2013
Kód zboží: NS-53519
Počet stran: 7
Přibližná hmotnost: 21 g (0.05 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Anotace textu normy ASTM F2306/F2306M-13 :
Keywords:
fittings, interior liner, PE, pipe, polyethylene, profile wall, sewer, subdrainage, ICS Number Code 93.030 (External sewerage systems)
Doplňující informace
| 1. Scope | ||||||||||||||||||||||
|
1.1 This specification covers requirements and test methods for annular, corrugated profile wall polyethylene pipe and fittings with an interior liner. The nominal inside diameters covered are 12 to 60 in. [300 to 1500 mm]. 1.2 The requirements of this specification are intended to provide pipe and fittings suitable for underground use for gravity-flow storm sewer and subsurface drainage systems. 1.3 This specification covers pipe
and fittings with an interior liner using a corrugated exterior
profile (1.4 Units—The values stated
in either SI units or inch-pound units are to be regarded
separately as standard. The values stated in each system may not be
exact equivalents; therefore, each system shall be used
independently of the other. Combining values from the two systems
may result in non-conformance with the standard.
1.5 The following precautionary caveat pertains only to the test method portion, Section 7, of this specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. |
||||||||||||||||||||||
| 2. Referenced Documents | ||||||||||||||||||||||
|
Doporučujeme:
