Potřebujeme váš souhlas k využití jednotlivých dat, aby se vám mimo jiné mohly ukazovat informace týkající se vašich zájmů. Souhlas udělíte kliknutím na tlačítko „OK“.
Standard Test Method for Determining Relative Humidity in Concrete Floor Slabs Using in situ Probes (Includes all amendments and changes 1/9/2020).
Přeložit název
NORMA vydána dne 1.12.2019
Označení normy: ASTM F2170-19a
Datum vydání normy: 1.12.2019
Kód zboží: NS-980489
Počet stran: 7
Přibližná hmotnost: 21 g (0.05 liber)
Země: Americká technická norma
Kategorie: Technické normy ASTM
Keywords:
concrete, flooring, floors, moisture, relative humidity,, ICS Number Code 91.080.40 (Concrete structures)
Significance and Use | ||||||
5.1 Excessive moisture in floor slabs after floor covering has been installed can cause floor covering system failures such as debonding, peaking and deterioration of finish flooring and coatings and microbial growth. 5.2 Manufacturers of such systems generally require moisture testing to be performed before installation on concrete. Internal relative humidity testing is one such method. 5.3 Moisture test results indicate the moisture condition of the slab only at the time of the test and in the specific locations tested. |
||||||
1. Scope | ||||||
1.1 This test method covers the quantitative determination of percent relative humidity in concrete slabs for field or laboratory tests. 1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard. 1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. Specific warnings are given in Section 7, 10.3.2, and 10.4.4. 1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee. |
||||||
2. Referenced Documents | ||||||
|
Poslední aktualizace: 03.11.2024 (Počet položek: 2 209 203)
© Copyright 2024 NORMSERVIS s.r.o.